INSTALLATION GUIDES:
Step 3:
You can adjust the viewing angle by adjusting the display screen directly. If it is too loose, you
can tighten the nuts by wrench as the below drawing shown. (Figure4)
±90°
C
Figure 4
PAY EXTRA CARE AND ATTENTION WHEN YOU FASTEN TV MOUNTS
TO THE BACK PANEL OF TV IN STEP 2 . MAKE SURE THE APPROPRIATE
MOUNT HARDWARE IS BEING USED PROPERLY .
±360°
LCD/LED
Monitor Display
Double Arm Wall Mount
+15°
-15°
1. Select correct Mounting Hardware according to the screw hole size of your TV, discard any
remaining screws or spacers.
2. Carefully lay your TV on its face on a non-abrasive surface, making sure to lay padding
underneath it so as not to damage the screen .
3. Place left TV mount and right mount in the approriate position, making sure CENTERED on
the back of the TV and LEVEL with on another
** For details and updated Command and Program Software,
please visit and download from www.abtussingapore.com
*Specifi cations are subject to changes without notice.
ABtUS SINGAPORE PTE LTD www.abtussingapore.com
ABtUS SIGAPORE PTE LTD www.abtussingapore.com
ABtUS SINGAPORE PTE LTD www.abtussingapore.com
Model: AV541
Revision 0
User Operation Guide
● Please read this instruction carefully before assembling.
● Fits for 19”-32” plasma and LCD TV.
● Max. load Capacity : 15KG (33 LBS).
PACKAGE CONTENTS
Parts list
Item 1
Wall Plate - 1 pc
Hardware for TV Assembly
Assembly hardware
1
A-lag bolt 4pcs
2
B-Anchor 4pcs
3
C-Spanner 1pc
4
D-4mm Alley key 1pc
Concrete
Wood Double Stud
B
Figure 1
16"
40.64cm
Figure 2
INSTALLATION GUIDES:FEATURES:
Step 1:
Hold wall plate (I) against wall at desired
A
UP
Ⅰ
A
position , then using a pencil mark the
locations of the 2 holes. Then drill holes
according pencil marks using 2/5” or 10mm
size drill bit to a depth of 2.4”/60mm.
If you mount TV mount into studs , pre-drill
the mark 2 holes using 4mm drill bit, fix wall
plate (I) to the wall with screws(A). If you are
not mounting into studs, then you will need
to use wall anchors(B). Insert wall anchors(B)
into holes, you may need to use hammer to
lightly tap wall anchors into wall. Then fix wall
plate(I) to the wall with screws (A) .
a) M4X15 bolt 4pcs
b) M4X30 bolt 4pcs
i) M8 spacer 4pcs
c) M5X15 bolt 4pcs
d) M5X30 bolt 4pcs
j) M5/M6 spacer 4pcs
e) M6X15 bolt 4pcs
f) M6X30 bolt 4pcs
k)M5/M4 washer 4pcs
g) M8X20 bolt 4pcs
h) M8X40 bolt 4pcs
L) M6 washer 4pcs
Step 2:
Fix TV plate to the back panel of TV
(Figure 3)
Ⅰ
Figure 3
*Specifi cations are subject to changes without notice.
Loading...