© 2013 Abstract Data Ltd. http://www.abstractdata.biz info@abstractdata.biz Version 1.0 June 2013
64&3(6*%&
"%&8"7,
4 Stage Waveform and CV Utility Module
Page 2 of 3
INTERNAL CV: Manual CV control for stage 1
EXTERNAL CV: Attenuation for external CV input for stage 1
INTERNAL CV: Manual CV control for stage 2
EXTERNAL CV: Attenuation for external CV input for stage 2
INTERNAL CV: Manual CV control for stage 3
EXTERNAL CV: Attenuation for external CV input for stage 3
SIGNAL IN: Signal input for stage 1
CV IN: CV input for stage 1
SIGNAL OUT: Signal output for stage 1
SIGNAL IN: Signal input for stage 2
CV IN: CV input for stage 2
SIGNAL OUT: Signal output for stage 2
SIGNAL IN: Signal input for stage 3
CV IN: CV input for stage 3
SIGNAL OUT: Signal output for stage 3
SIGNAL IN: Signal input for stage 4
NNV HWR OUT: Signal output 1 for stage 4
INV HWR OUT: Signal output 2 for stage 4
© 2013 Abstract Data Ltd. http://www.abstractdata.biz info@abstractdata.biz Version 1.0 June 2013
1: Front
Page 3 of 3
OVERVIEW:
4 stage waveform & CV utility module
Independent stages, 8 functions in total
DC-coupled ins & outs for each stage
Works with Audio, LFOs, CV, Logic & EGs
External CV control & on-board attenuation
Indicator LEDs for positive & negative cycles
Power supply reverse-voltage protection
Low-profile build mounts in any depth rack
STAGE 1: Attenuversion:
Voltage controlled or manual
Up to 100% attenuation
Up to 2x gain
Non-inverted or inverted output
Attenuation:
Voltage controlled or manual
Up to 100% attenuation
Non-inverted or inverted output
Voltage Controlled Amplifier/Gain:
Voltage controlled or manual
Up to 100% attenuation
Up to 2x gain
Non-Inverted or inverted
STAGE 2: Biasing:
Voltage controlled or manual
Up to +/- 10V
CV Source:
Up to +/-10V DC (at output, with no inputs present)
Attenuation:
Up to 100% Attenuation (at output, of signal at CV input)
STAGE 3: Bipolar Clipping:
Voltage controlled or manual
Up to 100% clipping (100% attenuation)
STAGE 4: Half-Wave Rectification:
Voltage controlled or manual
Positive-going, non-inverted, half-wave rectification (Positive output)
Negative-going, inverted, half-wave rectification (Positive output)
PRECAUTIONS: The ADE-30 uses the Doepfer standard for power connection and cable
orientation. The RED stripe on the supplied power cable connects to the
NEGATIVE (-12V) rail on the ADE-30 with the RED stripe facing DOWN.
This is marked on the back of the ADE-30 PCB as “-12 RED”.
The ADE-30 has diode and polyfuse protection built in but an incorrectly
connected cable may still cause damage to the module or the power supply.
The rear panel of the ADE-30 has exposed parts and connections. Please
ensure when handling the ADE-30 that the unit is held by the sides of the
front panel or the sides of the PCB.
CREDITS: Rory Dow
Dave White
© 2013 Abstract Data Ltd. http://www.abstractdata.biz info@abstractdata.biz Version 1.1 June 2013
2: Technical
Loading...