Abocom Systems WP102 User Manual

WP102

802.11b Wir eless Access Point

User’s Guide

1

FCC Certifications

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

 Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body.

CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.
All trademarks and brand names are the property of their respective proprietors.
Specifications are subject to change without prior notification.

2

Catalog

Introduction .....................................................................................................4

How to connect to the web server of AP.........................................................4

Upgrade Firmware in AP.................................................................................9

Save/Reload Settings of AP...........................................................................10

Set Account and Password for accessing web server of AP..........................11

3

Introduction

The WP102 is an IEEE802.11b compliant Access Point, which provides a powerful
high-speed wireless connection for compatible wireless-enabled devices into the network
with the freedom to roam. The WP102 provides 64/128 bit WEP encryption and
IEEE802.1x which ensures a high level of security to protects users’ data and privacy. The
MAC Address filter prevents the unauthorized MAC Addresses from accessing your
Wireless LAN. Your network security is therefore double assured. Plus, the web-based
management is easy to use that your wireless network connection is ensured to be always
solid and hassle free.

How to connect to the web server of AP

In order to configure the settings of AP, you have to connect to the web server of AP first.

(1) The default IP of AP is 192.168.1.254, in order to connect to the web server of AP

(a) connect PC to the AP through a UTP cable, the connection is like the following

graph.

Or, you can also connect to the AP by a wireless network card and follow the same
steps.

(b) set the IP of LAN card in PC to the same subnet as the IP of AP

4