Abocom Systems WAP5508 User Manual

4

2. Installing USB Ethernet 10/100 Driver

Abocom

WAP5508

2.1. Install to Windows XP

Follow the below steps to install the USB Ethernet 10/100 driver. It needs about 1 minute to complete.

1. Power on your computer and make sure that the USB port is enabled and working properly.

2. Plug the Universal Linker in PC’s USB port, there appears a windows about ”Found New Hardware” on the desktop.

3. It will popup installation wizard, please select “No, not this time”, and click “Cancel”.

4. After popup the warring message, please click “Continue Anyway”.

5

5. It will popup hardware installation wizard again, please select “Yes, this time only” and click “Next >”.

6. Please select “Install the software automatically (Recommended)”, and click “Next >”.

6

7. Click “Continue Anyway” to install Realtek USB Remote NDIS Device.

8. Click “Finish” to complete the installation.