Abocom Systems VM101R01, VM101T01 User Manual

60GHz WirelessHD

Transceivers

User Manual

Federal Communication Commission

Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interfere nce, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

In order to comply with FCC RF Exposure requirements, a separation distance of at

least 20 cm must be maintained between the antenna an d all pe rsons. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

z Reorient or relocate the receiving antenna. z Increase the separation between the equipment and receiver . z Connect the equipment into an outlet on a circuit different from that to which the

receiver is needed.

z Consult the dealer or an experienced radio/TV technician for help.

Table of Contents

CHAPTER 1: INTRODUCTION...................................................................................................................................1

OVERVIEW.......................................................................................................................................................................1

FEATURES........................................................................................................................................................................1

PACKAGE CONTENTS.........................................................................................................................................................2

APPLICATION DIAGRAM....................................................................................................................................................2

CHAPTER 2: HARDWARE INSTRUCTION.............................................................................................................3

60GHZ WIRELESSHD TRANSMITTER................................................................................................................................3

TX Front Panel Configuration TX Rear Panel Configuration TX Side Panel Configuration

60GHZ WIRELESSHD RECEIVER ...................................................................................................................................... 6

RX Front Panel Configuration RX Rear Panel Configuration RX Side Panel Configuration

REMOTE CONTROLLER......................................................................................................................................................8

CHAPTER 3: INSTALLATION.....................................................................................................................................9

SET UP STEPS..................................................................................................................................................................9

CHAPTER 4: SOFTWARE UPGRADE...................................................................................................................... 12

SOFTWARE APPLICATION INSTALLATION..........................................................................................................................12

START TO UPGRADE .......................................................................................................................................................16

CHAPTER 5: SPECIFICATIONS..............................................................................................................................19

SPECIFICATIONS.............................................................................................................................................................19

................................................................................................................................3

.................................................................................................................................4

..................................................................................................................................5

................................................................................................................................6

.................................................................................................................................7

..................................................................................................................................7

Video Format Audio Format

.........................................................................................................................................................20

Chapter 1: Introduction

Overview

For coming huge flat TV screen and high definition resolution, users like to set up the AV system in living room, but the cable placement always is a great harassment to the interior house. Also the HDMI cable is as expensive as the length as be. Users deserve to have a wireless cable replacement to match their high class AV systems. Here shows up a high edge solution to meet users’ equipment: 60GHz WirelessHD Audio-V ideo Transceivers!

This elegant product has HDMI interface to take multiple content sources like multimedia center, Blue ray player and Set-Top Box, without compressing of content, the WirelessHD technology will offer multiple gigabit throughout for Full HD video transmission. Users do not need to worry about video quality for lower transmission bandwidth anymore. It also has compliance to WirelessHD, HDMI, and DTCP for content security and quality assurance.

Features

 36 antennas array  Auto tracing - smart antenna  Least interference - 60GHz transmission  1080P 60f 50 Hz/ 59.94 Hz/ 60Hz global capability  Full HD 1080P 60f non-compressing image wireless transmission  Support HDCP/ DTCP for content security and quality assurance  4Gb/sec. wireless transmission  Multiple TX to single RX availability

Package Contents

The following items should be included:

z 60GHz WirelessHD transmitter unit z 60GHz WirelessHD receiver unit z User manual z Remote controller

If any of the above items are damaged or missing, please contact your dealer immediately.

z Two-piece of HDMI cables z Two-piece of power adapters z Warranty leaflet

Application Diagram

Notice!

For better transmitting quality, we strongly recommend to put the 60GHz WirelessHD Transceivers horizontally in open space, do not put them into cabinet or cupboard that will reduce the wireless transmitting signal.

Chapter 2: Hardware Instruction

60GHz WirelessHD Transmitter

TX Front Panel Configuration

TX LED Indicators

LED Color Behavior Indication

The LED will illuminate when the power is connected and the power switch is turned on.

The LED will be dark when the power switch is turned off.

The LED will illuminate to indicate which RX is being selected.

If the pairing LED is off, user has to re-select again or reset both devices.

The LED will illuminate when the signal is weak.

Power

Pairing

Weak

Green

Off Blinking Unit in sleep mode. On

Blue

Off Blinking Waiting for link. On

Green

Off No link or no signal

The LED will illuminate when the signal is

Strong

Green

strong.

Off Signal weak

If 4 LEDs are blinking at same time, that means fan does n’t work, please turn off unit

and send to serv ice station.

TX Rear Panel Configuration

Configuration DC-IN

Switch

HDMI

RS232 D-Sub

Connect the power adapter to the power DC-IN port. Switch the button to turn on or off the power supply.

Connect HDMI cable one end to this HDMI port and the other to the DVD player or computer HDMI port.

Connect the RS232 D-Sub cable one end to this port, the other to the computer or laptop RS232 D-Sub port.

TX Side Panel Configuration

TX Buttons

Reset

CFG (Configure)

No function

Press the “RESET” button to reset the system, the system will run through a full reset which takes approximately 5 seconds.

This button is for upgrade system firmware. For further firmware upgrade process, please refer to Chapter 4:

Software Upgrade.

This button is fixed and no function here.

+ 16 hidden pages