Abocom Systems SDW11GM Quick Install Guide

INSTALLING THE DRIVER

Installation of the Mini SD WLAN Card Driver to the Pocket PC
using Microsoft Active Sync®

1. Connect your PDA to your computer and make sure Active-Sync® has
established a connection between the two devices.

2. Insert the included CD-ROM to your PC. The main screen will appear,
click Install Driver to start driver installation.

1

Note: Do not insert the Mini SD WLAN Card into the card slot of
your PDA until the Driver installation has been performed.

3. Click “YES” to continue the installation.

4. Click “OK” to complete the driver installation.

ACCESSING THE WLAN UTILITY

1. Insert the Mini SDIO Wireless LAN Card into the SD slot of your
PDA

2. Go to Start > Set tings > Connections tab > Wireless Ethernet to access
the Windows CE built-in WLAN utility

2

CONFIGURING WLAN UTILITY

Select an available AP or router from the list and tap Connect to make a
connection.

3

Wireless tab

Wireless Network Select an available network device from

the list and tap Connect.

Network to access Select the type of network access from

the pull-down list.
All available: A group of wireless
devices communicating with both
access points and network adapters.
Only access points: A group of
wireless devices communicating
directly with only access points.
Only computer-to-computer: A group
of wireless devices communicating
directly with each other without the use
of an access point.

Automatically connect to
non-preferred networks

Tap the checkbox to enable this
function, if the Automatically connect
to non-preferred networks is enabled,
your device will detect all the new
networks for you to configure.

4