Abocom Systems SDM3100 User Manual
1
802.11a/b/g SDIO
WiFi Module
User Manual
Table of Contents
INTRODUCTION ..............................................................................................5
FEATURES .........................................................................................................5
INSTALL THE DRIVER...................................................................................7
ACCESS THE WLAN UTILITY ......................................................................7
CONFIGURE WIRELESS NETWORKS.........................................................8
TROUBLESHOOTING ...................................................................................11
SPECIFICATIONS ...........................................................................................13
2
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
This device and its antenna(s) must not be co-located or operation in conjunction
with any other antenna or transmitter.
This device is going to be operated in 5.15~5.25GHz frequency range, it is
restricted in indoor environment only.
3
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
IMPORTANT NOTE:
This module is intended for OEM integrator. The OEM integrator is still
responsible for the FCC compliance requirement of the end product, which
integrates this module.
20cm minimum distance has to be able to be maintained between the antenna
and the users for the host this module is integrated into. Under such
configuration, the FCC radiation exposure limits set forth for an
population/uncontrolled environment can be satisfied.
Any changes or modifications not expressly approved by the manufacturer could
void the user's authority to operate this equipment.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep
at least 20cm separation with the antenna while this end product is installed and
operated. The end user has to be informed that the FCC radio-frequency
exposure guidelines for an uncontrolled environment can be satisfied. The end
user has to also be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this
equipment.If the size of the end product is smaller than 8x10cm, then additional
FCC part 15.19 statement is required to be available in the users manual: This
device complies with Part 15 of FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following "
Contains TX FCC ID: MQ4SDM310". If the size of the end product is larger than
8x10cm, then the following FCC part 15.19 statement has to also be available on
the label: This device complies with Part 15 of FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
4
INTRODUCTION
An IEEE 802.11a/b/g SDIO WiFi Module work for various applications. The 802.11a/b/g
SDIO WiFi Module is a compact size wireless module for cellular handset and consumer
electronic devices that require low power consumption. The module works with a lot of
wireless LAN security protocols. Open, 64-bit and 128-bit WEP encryptions are
supported.
FEATURES
Module size as 20 x 20 x 3.0 mm.
Host interface support for SDIO.
Supports the IEEE802.11 wireless.
High radio performance.
Low power consumption.
Data rates of 6-54Mbps for 802.11a and 1-54Mbps for 802.11g.
Embedded 40MHz reference clock supported.
Sleep clock using 32 KHz clock.
Ready OS support as WinCE 5.0 and 6.0, Linux 2.6.9.
SD WLAN MODULE WIRELESS NETWORKS
The SD WLAN Module enables you to:
Connect your computer to a Peer-to-Peer workgroup of wireless computing devices.
Connect your computer to a Small Office/Home Office (SOHO) network that
includes Wi-Fi access points.
Connect your computer to a Local Area Network (LAN) Infrastructure that includes
the SD WLAN Module or other IEEE 802.11 a/b/g compliant LAN systems.
Wireless stations can be equipped with the SD WLAN Module, but also with other
WLAN PC Cards. Both the SD WLAN Module and the WLAN PC Card share the same
wireless functionality.
Peer-t o -Peer ( A d -h o c ) W o rk g ro u p
5
Loading...