Abocom Systems FJ36P User Manual
10.4” Wireless
Thin Client
REGULATORY NOTICES
Federal Communications
Commission Notice
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and radiates radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
This equipment marketed in the USA is restricted by firmware to only operate on
2.4GHz channel 1-11.
CAUTION! Danger of explosion if an improper battery is substituted. If a
replacement is needed, only replace with a manufacturer issued battery pack.
Do not dispose of the battery pack in fire. They may explode. Check with local
authorities for proper disposal instructions.
Exposure to Radio Frequency Radiation.
The antenna used for this transmitter must be positioned to provide a separation
distance of at least 20cm form all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.
TABLE OF CONTENTS
1. GETTING STARTED.............................................................1
1.1. WELCOME ..................................................................................1
1.2. SAFETY INSTRUCTIONS AND CARE OF YOUR WIRELESS THIN
CLIENT ..................................................................................................1
1.3. CHECKLIST .................................................................................3
2. GETTING TO KNOW YOUR WIRELESS THIN CLIENT
5
2.1. PARTS NAMES ............................................................................5
2.2. THE CRADLE (OPTIONAL)...........................................................8
2.3. THE BATTERY AND AC ADAPTER ..............................................9
2.4. THE STYLUS .............................................................................10
2.5. TOUCH-SCREEN DISPLAY..........................................................11
2.6. DISPLAY PROPERTIES ...............................................................11
2.7. THE CRADLE (OPTIONAL).........................................................11
3. MANAGING YOUR INFORMATION...............................12
3.1. DATA INPUT .............................................................................12
Software Keyboard..................................................................12
3.2. DATA SYNCHRONIZATION ........................................................13
4. CONNECTING OTHER DEVICES ...................................17
5. GETTING ONLINE ..............................................................18
6. TROUBLESHOOTING........................................................19
1. Getting Started
1.1. Welcome
Congratulations! With your new Wireless Thin Client you will be
able to create, manage and share information, send and receive email,
and carry out research from virtually anywhere! Your Wireless Thin
Client gives you freedom; easy access to the Internet, and the
800X600 SVGA screen offers high resolution for all your Tablet
uses.
This manual will guide you through the Tablet’s simple set-up,
introduce you to its range of features and help you source extra
information.
1.2. Safety Instructions and Care of your Wireless Thin
Client
CAUTION! Danger of explosion if an improper battery is
substituted. If a replacement is needed, only replace with a
manufacturer issued battery pack.
• During normal usage and charging, the battery pack heats up.
This is caused by energy that has been generated and a chemical
charge that has occurred inside the battery pack. This is not a
cause for concern.
• You should charge batteries at temperatures from 10°C to 30°C
(from 50 °F to 85 °F). Lower temperatures require a longer
charging time.
• Do not carry a battery in your pocket, purse, or other container
where metal objects could short-circuit the battery pack. The
- 1 -
resulted excessive current flow can cause extremely high
temperatures and may result in damage from burns.
• Do not use your Wireless Thin Client in a wet environment, for
instance, near a bathtub, sink, or any other place where there is
risk of moisture.
• To help prevent electric shock, plug the AC adapter into a three
prong, grounded power source. If a two-prong extension plug is
absolutely needed, use a 3-wire cable with properly grounded
plugs.
• If your Wireless Thin Client includes a modem PC Card,
disconnect the modem cable during electrical storms to avoid the
remote risk of electrical shock from lightening via the telephone
line.
• PC Cards may increase in temperature over an extended period
of use. Use care in handling these cards.
Do not dispose of the battery pack in a fire. They may explode.
Check with local authorities for-proper disposal instructions.
• When traveling, never check your Wireless Thin Client as
baggage.You can put your Wireless Thin Client through an X-ray
security machine, but never put your Wireless Thin Client
through a metal detector. Have a charged battery with you in case
you are asked to turn on the Tablet.
• When traveling, do not place the Wireless Thin Client in an
overhead compartment where it can slide around. Do not drop
your Wireless Thin Client or subject it to mechanical shocks.
• Protect your Wireless Thin Client from environmental hazards
such as dirt, dust, food, liquids, temperature extremes, and over
exposure to sunlight.
• When you change environments rapidly, in respect to
temperature and humidity, with your Wireless Thin Client,
condensation may form on or within the Tablet. To avoid
- 2 -
potential damage to your Wireless Thin Client, allow sufficient
time for the moisture to evaporate before using.
• When disconnecting cables from your Wireless Thin Client, be
sure to pull on the connector or the strain relief loop, not on the
cable itself. As you pull, keep it evenly aligned to avoid bending
the connector pins. Never force a connector into a port. Make
sure the connector and port are aligned correctly.
• Before you clean your Wireless Thin Client, turn it off, remove
the battery, and unplug the power source.
• Clean your computer with a soft cloth dampened with water
rather than with liquid or aerosol cleaners.
• Clean the screen with a soft, clean cloth and commercial window
cleaner that does not contain wax or abrasives. Always apply the
cleaner to the cloth, not the screen. If the display contains grease
or some other contaminant, use isopropyl alcohol instead of
commercial cleaner.
1.3. Checklist
Check to see that the package your Wireless Thin Client came in
includes these items:
• Wireless Thin Client
• AC Adapter
• Power Cord
- 3 -
• Battery Pack
• Stylus
• User Guide
- 4 -
Loading...