ET-UW100
802.11n/b/g compliant 2.4GHz WiFi System USB Dongle
APO Generic
User Guide
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of
other channels is not possible.
This device and its antenna(s) must not be co-located or operation in conjunction with any other
antenna or transmitter.
IMPORTANT NOTE:
Federal Communication Commission (FCC) Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in ANSI/IEEE
C95.1-1999 and had been tested in accordance with the measurement methods and procedures
specified in OET Bulletin 65 Supplement C. This equipment should be installed and operated with
minimum distance 0.5 cm between the radiator & your body.
IC Statement
This Class B digital apparatus complies with Canadian ICES-003.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of
the device.
Cet appareil numérique de la classe B est conforme á la norme NMB-003 du Canada.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of
other channels is not possible.
This device and its antenna(s) must not be co-located or operation in conjunction with any other
antenna or transmitter.
IMPORTANT NOTE:
IC Radiation Exposure Statement
This EUT is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102
and had been tested in accordance with the measurement methods and procedures specified in IEEE
1528. This equipment should be installed and operated with minimum distance 0.5cm between the
radiator & your body.
Table of Contents
Chapter 1: Introduction 5
Package Contents 5
How it works 5
System requirements 5
Appearance 5
ET-UW100 Image 5
Start using 6
Chapter 2: Utility control 7
Utility Form 8
Simple control 9
Update FW 9
Network Setting 10
IP Setting 11
Wireless Setting 11
WiFi Status 12
Refresh Button 12
Save button 12
Close Button 12
- 3 -
Chapter 1: Introduction
Package Contents
The following items should be included:
z 1pcs
ET-UW100
z 1pcs User manual
If any of the above items are damaged or missing, please contact your dealer immediately.
Notice: Abocom has the right to exchange the design of package and include items without inform the users.
System requirements
OS: Windows XP SP2 with administrator privilege. Windows Vista, Windows 7.
CPU: Intel Pentium M 1.7Ghz (2005) is workable at 5 frames per second.
For 15 frames per second, a dual-core CPU (2006) is recommended.
Graphic card: A stand-alone graphic card is recommended, but not required.ʳ
A good graphic card could double frame rate for a slow CPU.
ʳ
¾ Important Notice:
For better transmitting quality, we strongly recommend to put the wireless receiv er ho ri zontally in open space,
do not put them into cabinet or cupboard that will reduce the wireless transmitting signal.
- 4 -