Abocom Systems AOP7120 Users Manual

AOP7120 Super WiFi CPE/AP

2

3

1

LAN

WAN

Hardware Overview

Use standard LAN cables (RJ45

connectors) to connect your PCs to

this port. If required, any port can

be connected to other hub. Any

LAN port will automatically function

as an “Uplink” port when necessary.

1. Connect a 24V PoE switch to

get power with RJ45 cable.

2. Connect the ADSL or Cable

Modem to a PoE switch to get

Quick Install Guide

Login

1. Start your computer and make sure the

connection by an Ethernet cable between

your computer and the Wireless Router.

2. Start your WEB Browser.

3. In the Address box, enter the IP address:

192.168.1.1

4. Login User Name “admin” and Password

“password”

Internet connection. If your

modem came with a cable, use

the supplied cabled, otherwise,

use a standard LAN cable.

Hardware Connection

Step1. Connect to your local area network:

Step2. Power on the device: power on the

Step3. Check the LEDs: the power LED

connect the Ethernet cable to LAN

port of the device, and the other end

to a PC, hub, switch, router or other

Wireless Access Point.

device by PoE switch via WAN port.

should be always on when system is

ready.

Wireless_2.4G

DefaultSSID: OpenWRT2G

Security: none

Software Configuration

Wireless_5G

DefaultSSID: OpenWRT5G

Security: none

FCC Statement:

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one of the following measures:

● Reorient or relocate the receiving antenna.

● Increase the separation between the equipment and receiver.

● Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

● Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired operation.