FULL ROUND OVERLAPPING
GUY MARKER
INSTALLATION INSTRUCTIONS
STEP 1
STEP 2
Position Guy Marker so that top of Marker is
upward on the strand.
Note: the TOP end is located opposite of the
end with the zip tie.
Place the slit of the Marker on the strand.
Push the strand through overlap into center of
Marker as shown in Figure 2.
STEP 3
Continue application by simultaneously
rotating and pushing Marker onto strand.
In new construction just slide Marker onto
strand, and then apply deadend.
©Copyright 2014 Hubbell Incorporated | www.hu bbel lpowersystems. com | Adjust-A-Grip Installation
STEP 4
Continue rotating and pushing Marker onto
strand until strand is completely inside Marker,
and Marker can be freely moved up and down
strand.
2
STEP 5
STEP 6
Remove zip tie and insert zip tie strap through
the two slots.
Pull Marker down over deadend allowing
Marker to expand and conform to hardware
as required. Wrap zip tie strap around Marker
and hardware. Place the zip tie strap through
its self-locking tab. Pull tightly to secure
Marker.
COMPLETED INSTALLATION
©Copyright 2014 Hubbell Incorporated | www.hu bbel lpowersystems. com | Adjust-A-Grip Installation
3
About Hubbell Power Systems:
H u b b e ll Powe r Sy s t e m s (H P S ) m a n u f a ctu r e s a wid e va r i e t y of tr a n s m i s s i o n , di s t r i b u t i o n , su b s t a t i o n , O E M , un d e r g r o u n d an d co m m u n i cat i o n s pr o d u ct s
use d by utiliti es . HP S pro du cts are als o use d in the civil constr uct ion, trans portation, gas and wate r industries. Our prod uct line incl udes const ruction,
switching and protection products, hot line tools, insulators, arresters, pole line hardware, cable accessories, test equipment, transformer bushings,
connectors, grounding equipment and polymer precast enclosures and equipment pads.
Hubbell has a policy of continuous product improvement. Please visit hubbellpower systems.com to confirm current design specifications.
©Copyright 2014 Hubbell Incorporated | www.hu bbel lpowersystems. com | Adjust-A-Grip Installation
TD_06_034_E
Loading...