CROSS PLATE ANCHORS
Application/Installation
ANCHOR
APPLICATIONS
INSTALL IN THESE
CLASS SOILS
INSTALLING
EQUIPMENT
REQUIRED
LIMITATIONS
ON USE
STEP #1
Drill a vertical or angled hole.
For medium and heavy transmission guying. Installed in machine bored holes.
Load-based on using a 400 square inch anchor to a 24” hole.
Classes 3, 4, 5, 6 and 7 (100-600 inch-pound with the soil test probe)
Power digger, rod trenching tool, shovel and tamping bar.
Necessity of undercutting hole limits anchor depth. Rod trench should not be
large or holding capacity will be reduced. Both anchor hole and rod trench
must be backfilled and tamped.
STEP #2
Undercut the hole so that the anchor plate can be
installed at a right angle to the guy.
Undercut
STEP #3
Cut a rod trench with a trenching tool or a
small auger.
NOTE: Trench should be narrow to avoid
disturbing soil.
hubbellpowersystems.com
STEP #4
Assemble rod to anchor and install the anchor inside
the hole so that the rod is aligned within ±5° of the
guy.
NOTE: Improper alignment may reduce holding
capacity.
HOW TO USE CROSS PLATE ANCHORS
STEP #5
Thoroughly backfill and tamp the anchor hole and rod trench.
Rod Slot
TOP VIEW
ANCHOR/ROD TOP VIEW
ANCHOR/ROD BOTTOM VIEW
*Anchor and rod sold separately
hubbellpowersystems.com
For product inquiries, please contact your local sales
representative or customer service representative.
Because Hubbell has a policy of continuous product improvement,
we reserve the right to change design and specifications without notice.
©2020 Hubbell Incorporated.
Printed in the U.S.A. | TD_06_136_E
Loading...