Step 1:Put Part C and Part F together and put the Part A in the middle
of them,then use Screw① to tighten them.
Please note:Part C is not the same length as Part F!
2
1
/
Step 2:Use Nut③ and Srew② to connect two Part C(or Part F),and
tighten them.Then put one Part J on the bottom side of two attached
Part C(or Part F).Use Screw① to tighten the Part J.
2
Step 3: Insert the small head of Part H to the long side of Part D
directly and insert one Part K to the other head of Part H.
Then insert one Part K to the short side of Part D.Insert the small
head of Part G1 or G2 to Part E.
Repeat the steps above to assemble the other Part D,H,K,E,G1 and G2.
1
Step 4:Insert four Part H to the four corners of the frame (the top
of Part A) .
Then insert the other side(the bottom side of Part D) to Part L.
Step 5:Insert Part G1 to the connection part of the two attached Part F.
Then Insert Part G2(the shorter piece) to the connection part of the two
attached Part C.Next insert Part E to Part L.
Insert Part M to Part L.Please note:The Part E which is attched to G2
should connect to the short piece of Part L.The Part E which is
attached to G1 should connect to the long piece of Part L.
Step 6:Put the canopy fabric (Part P&Q) on the frame,extend it fully.
Put the heads of tubes(Part K) into the corner pocket of canopy fabric.
Step 7:Insert Part B to Part A,then turn it to make it tight.
Step 8:Insert the stakes(Part N) on the foot pad to the ground deeply,
use Part④(the plastic hook) to hang Part R on the frame,then you
can use the gazebo.
Loading...