Page 1
Page 2
Page 3
Step 1:Put two Part C together and put one Part A in
the middle of them,then use four Screw① to tighten
Part C and Part A.
Repeat the steps to assemble the other three Part A and six Part C.
Step 2:Use one Nut③ and Srew② to connect two Part C,and
tighten them.Then use two Screw① to tighten the Part J with two
attached Part C.
Repeat the steps above to assemble the other six Part C.
Step 3:Insert the small head of Part F to the long side of Part D
directly and insert one Part K to the other head of Part F.
Then insert one Part K to the short side of Part D.Insert the small
head of Part G to Part E.
Repeat the steps above to assemble the other Part D,F,K,E and G.
Step 4:Insert four Part F to the four corners of the frame (the top
of Part A) .
Then insert the other side(the bottom side of Part D)to Part L.
Page 4
Step 5:Insert Part G to the middle part of the two attached part C.
The other three Part G should be done as this.
Then insert the other head of Part E to Part L.Finally,Insert Part M
(the steel hook) to the hole of Part L and turn it to tighten it.
Step 6:Put the canopy fabric (Part P&Q) on the frame,
extend it fully.
Put the heads of tubes(Part K) into the corner pocket of
canopy fabric.
Step 7:Insert Part B to Part A,then turn it to make it tight.
Step 8:Insert the stakes(Part N) on the foot pad to the ground
deeply,then you can use the gazebo.
Loading...