WARNINGS
*Do not operate the Projector in direct sunlight or near heat sources such as
heaters, fires, and stoves as this may cause a fire hazard.
*Do not operate the projector close to sources of steam or oil such as a
humidifier as this may cause electric shock.
*Do not operate the projector near water such as by the sink or bathtub as this
may cause electric shock.
*Do not block or restrict airflow from ventilation holes as this may cause the
Projector to overheat.
*Do not place inflammable materials beside the projector as this may cause a fire
hazard.
*Do not drop the projector or allow heavy impacts or shock as this will damge the
projector.
1
GENERAL OPERATION
Focus Adjustment / Throw Distance – The focus can be adjusted by turning
the wheel located at the front of the projector. The Projector is capable of the
following throw and focus distances:
Diagonal size Diagonal size Vertical size Horizontal size Throw distance
(inch) (mm) (mm) (mm) (mm)
30 762 457 610 1250
40 1016 610 813 1666
50 1270 762 1016 2083
60 1524 914 1219 2499
70 1778 1067 1422 2916
80 2032 1219 1626 3332
90 2286 1372 1829 3749
100 2540 1524 2032 4166
Connecting an Audio/Video input source - The Projector can accept different
A/V (Audio/Video) sources through the A/V port. These sources are connected
through a 3.5mm A/V cable.
MAXIMUM SUPPORTED RESOLUTIONS
NTSC: 720x480
PAL: 720x576
Possible A/V sources: Composite (included), Iphone / Ipod (optional), Zune
(optional), Playstation Portable (optional), and others. Please check
www.aaxatech.com or your AAXA dealer for optional A/V cables.
Language – Supported languages include English, French, Spanish,
LCD Adjusment – the LCD adjustment changes the display output of the
TROUBLESHOOTING
THE PROJECTOR DOES NOT TURN ON
Possible Causes
Solution
There is no power
Check to ensure the power outlet or battery
source is good. Check the power adapter to
ensure a proper connection with the wall outlet
as well as the Projector.
The projector is in the shut-down cooling cycle
Wait until the Projector has fully cooled to
restart
NO PICTURE
Possible Causes
Solution
The video source is not properly connected
Check the video source signal to ensure that it
is properly connected
The correct input source has not been selected
Select the correct input source by pressing the
Source key on the remote.
IMAGE IS BLURRED
Possible Causes
Solution
The Projector is not in focus
Adjust the focus with the focus adjustment dial
until the image comes into focus
The Projector is offset from plane / angle of
operation
Move the projector so that it is at both 180
degrees and on an even plane with the screen.
Please see Page 9
SD CARD IS NOT RECOGNIZED
Possible Causes
Solution
SD Card is not inserted properly
Re-insert SD Card
SD Card is damaged
Replace SD Card
REMOTE CONTROL DOES NOT WORK
Possible Causes
Solution
The remote control battery is dead
Replace the battery with comparable CR2025
battery
The Projector is not receiving the infrared
signal
Ensure there are no obstacles blocking the
infrared signal to the Projector
16
Loading...