
User Manual
MODEL:98801(RX), AA-001(TX), AA-002(TX),
1 product description
1.1、input volt: AC 120V 12A 60Hz MAX:1440W
1.2、 input power supply and output outlet meet UL standard
1.3、 Product has wireless control function and with 2 pcs RF remote
1.4、 There is one grounded outlet on the right side of RF Receiver
2 Operating instruction
2.1、Wireless radio frequency remote controls are the easiest way to add switched outlet convenience without
wiring or the need for an electrician. Simply plug the desired appliance into the receiver and the receiver into
any outlet. A press of the handheld transmitter's button turns whatever is plugged into receiver On or Off. Easy
handheld transmitter can be taken anywhere or attached to keys.
RF Receiver
RF Wall switch Remote
RF Keychian Remote

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Company Name: Aaron & Andrew Design Inc
Address:
2F, # 2, Alley 19, Section 1, Wan-Mei Street, Mu-Ga, Taipei, Taiwan