A4Tech RK7 Users Manual

PowerSaver R7

Wireless Desktop

User’s Guide

Model: RK-7&R7-70D

www.a4tech.com

R7 PowerSaver Wireless Optical Mouse

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1)
THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

Federal Communications Commission Requirements

The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to
radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:

z Reorient of relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
z Consult the dealer or an experienced radio/TV technician for help.

The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.

- 1 -

R7 PowerSaver Wireless Optical Mouse

INTRODUCTION

Congratulations on your purchase!
Congratulations on your purchase!
PowerSaver R7 Wireless Desktop is the optimal high science products for power & desktop space saving. Its
innovative lightweight, mini & thin wireless keyboard design gives you a consistent desktop look as well as an
amazingly high level of comfort. your new RF-Mouse is designed with R7 Extremely Low-Power Technology only
requires 8mA electric current while others require 25mA. Wow! Just turn your mouse battery –life 3 times longer.
Same time, PowerSave R7 performs high-speed RF technology with report rate of 125Hz

mice performs with reports rate of only 90Hz (Tested by Mouse Rate Program)]

z Package contains：
PowerSaver R7 Wireless Keyboard
PowerSaver R7 Wireless Optical Mouse
USB RF Receiver
USB Extension Cable
4 AAA Alkaline Batteries
User’s Quick Guide
CD Driver

- 2 -

[**Normal wireless optical

R7 PowerSaver Wireless Optical Mouse

z System Requirements:
To use the mouse presenter, your computer must meet the following hardware requirements and run one of the
operating system listed below.

Hardware

1. IBM or compatible system

2. UBS v1.1 or higher interface

3. Hard Disk Driver

4. USB Port

Operating System

Windows®98/Me/2000/2003/XP/x64

z This user’s guide describes how to：

1. Connect the receiver to your computer

2. Set up the wireless link and use the mouse
3 .Install software driver

- 3 -

R7 PowerSaver Wireless Optical Mouse

Inserting the Batteries

z Install 2 AAA alkaline（or rechargeable batteries）in the

wireless keyboard.

1. Remove the battery compartments cover on the bottom of the
keyboard by squeezing the cover in front the tab to release it.

2. Insert the batteries; make sure to properly orient the positive (+)
and the negative (-) ends as specified by the battery compartment
labels.

3. Replace the cover.

z Install 2 AAA alkaline（or rechargeable batteries）in the wireless mouse.

1. Press the tab on the bottom of the mouse cover as shown here and remove the cover.

2. Insert the supplied batteries, making sure that the positive (+) and negative (-) ends of the battery match the

polarity indicators inside the battery housing.

3. Slide the batter cover back into position until it “clicks” firmly into place.

- 4 -

R7 PowerSaver Wireless Optical Mouse

Step1 Step2 Step3

To connect the receiver

Insert the Receiver USB port connector into the available computer USB port. You can choose anyway to
connect the USB receive with computer as blow:

For PC computer usage:

1. Insert the USB receive mouse port connector into the USB port on the
USB extend cable (accessories),

- 5 -