A4Tech RFKB5 Users Manual

Quick Start Guide

Getting Ready

1. Turn off the power of your computer.

2. Remove the existing keyboard (and mouse for the A4Tech® Wireless

Desktop).

3. Install the AA alkaline batteries in the Wireless keyboard. Remove the battery

compartment cover on the bottom of the keyboard by squeezing the cover in
from the tab to release it.

THE MANUFACTURER IS NOT RESPONSIBKE FOR ANY RADIO OR TV INTERFERENCE CAUSED
BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.SUCH MODIFICATIONS COULD
VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates. uses and can radiate radio
frequency energy and, if not install and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on ,the user is encouraged to try to correct the interference
by one or more o the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

1

Setting Up the Keyboard or Wireless Desktop

1. Make sure that your computer is turned off.

2. Connecting the Receiver’s Keyboard Cable:
(a) When connecting to an IBM AT keyboard port, use the 5-pin DIN

connector already attached to the keyboard cable.

(b) When connecting to a PS/2-style, 6-pin DIN keyboard port, remove

the AT adapter.

(c) Connect the receiver’s purple keyboard cable to the computer’s keyboard port.

3. Place the receiver eight inches (20

centimeters) from any electromechanical
device.

Installing the Keyboard Software­iKeyWorksOffice

Before you can take advantage of the many features
your keyboard offers, you must install the driver.
The driver is in the installation diskette that came
packaged with your mouse and keyboard
Windows 95/98/Me/2000/NT4.0 installation
Insert the installation diskette into your floppy disk drive.
Click the Start button and then click Run.
In the Run dialog window, type A:\setup, where “A” is the letter of your floppy disk drive.
Click OK and follow the instructions on your screen to complete the installation.

Selecting the Frequency Channel

The Wireless keyboard operates on two frequency channels ..
Refer to the following to change the frequency channel for your
keyboard: Set the frequency channel on the receiver to 1 or 2. Set
the frequency channel on the keyboard to 1 or 2.

The Wireless keyboard ID code

Each keyboard is assigned a unique ID code at manufacture, so the receiver
only picks up the signal from your mouse and prevents other Wireless
keyboard radio signals from operating on your computer. This feature can
also be disabled, allowing other Wireless pointing devices to operate your
computer.

2