THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO
THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Federal Communications Commission Requirements
The equipment has been tested and found to comply with the limits for Class B Digital Device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction, may
cause harmful interference to radio communication. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
●Reorient of relocate the receiving antenna.
●Increase the separation between the equipment and receiver.
●Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
●Consult the dealer or an experienced radio/TV technician for help.
THE CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY
RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO OPERATE THE
EQUIPMENT.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and receiver.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC Radiation Exposure Statement
The equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and
meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. The
equipment has very low levels of RF energy that it is deemed to comply without testing of specific
absorption ratio (SAR).
About "16-in-One" software
Consists of value-added functions, such as: Multi-link management, DPI / report rate setting, 4-way
wheel, power-saving management, battery status indication, etc.
Best software for your every need!
Define the Mouse Buttons
1. Double-click the icon " " at the system tray
to open the “Main Menu”.
2. Select the function you preferred for each
button from the pull-down function list.
3. Store and apply the setting by clicking
"Apply".
4. Click “Exit”.
Gesture 16-in-1
Select “Gesture 16-in-1” from the pull-down function list of the mouse RIGHT button , the setup box
will pop up.
You may set up 16 user-friendly functions/commands to the defined gesture RIGHT button, including
the functions of Keyboard/Mouse simulation, Open a file, Office, Text, Multimedia, Internet, etc.
Press/hold the gesture RIGHT button and draw a line in the direction described to perform the preset
functions/commands.