
Specications
Specications
IDEAL LIFE Pod™ Model: ILP 0001 IDEAL LIFE Pod™
Display: LED’s
Power Source: AC adapter
OperatingTemperature/Humidity: 10°C- 40°C/Below 85% relative humidity
Storage Temperature/Humidity: -5°C- 50°C/Below 90% relative humidity
ConsoleWeight: Approx. 142 g without batteries
Outer Dimensions: Approx. 120mm Width x 105mm Depth x 30mm Height
Note: These specications are subject to change without notice.
11

FCC Statement
FCC Statement
Interference Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates and can radiate radio frequency energy.
If not installed and used in accordance with the instructions the Pod could interfere with radio
communications. There is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception (which can be determined by
turning the equipment off and on) you may be able to correct it by:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into a different outlet circuit than the receiver
• Consult the dealer or an experienced radio/TV technician for help
FCC Number is located on the Cabinet Bottom.
12

FCC Caution: To assure continued compliance, any changes or modifications
not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment. (Example - use only shielded
interface cables when connecting to computer or peripheral devices).
End Product Labeling
This transmitter module is authorized only for use in devices where the
antenna may be installed such that 20 cm may be maintained between the
antenna and users. The final end product must be labeled in visible area with
the following: “Contains FCC ID: TS8ILP0001B.”
”
End Product Manual Information
The user manual for end users must include the following information in a
prominent location “IMPORTANT NOTE: To comply with FCC RF exposure
compliance requirements, the antenna used for this transmitter must be
installed to provide a separation distance of at least 20cm from all persons and
must not be colocated or operating in conjunction with any other antenna or
transmitter.” This device complies with part 15 of the FCC rules. Operation
is subject to the following two conditions (1) This device may not cause harmful
interference and (2) This device must accept any interference received,
including interference that may cause undesired operation.
IMPORTANT NOTE: In the event that these conditions can not be met (for
example certain laptop configurations or colocation with another transmitter),
then the FCC authorization is no longer considered valid and the FCC ID can
not be used on the final product. In these circumstances, the OEM integrator
will be responsible for reevaluating the end product (including the transmitter)
and obtaining a separate FCC authorization. This device is intended only for
OEM integrators under the following conditions: The antenna must be installed
such that 20 cm is maintained between the antenna and users. As long as a
condition above is met, further transmitter test will not be required. However,
the OEM integrator is still responsible for testing their end product for any
additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.).