3G GREEN GREEN GLOBE M4L3OCC10 Users Manual

This product meets the safety regulation of FDA, FCC, and CE

1. FCC Requirements Radio & Television Interference
Warning: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy, and if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:

1).Reorient or relocate the receiving antenna.

2).Increase the distance between the equipment and receiver.

3).Connect the equipment into a separate power outlet from which the receiver is
connected.

4).Consult the dealer or an experienced radio/TV technician for solution.

Note:

1. The changes or modifications not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.

4

2.4GHz LASER RF Hand Track User Guide

Installing your Wireless HAND TRACK

Hardware Installation

1. Install the Batteries

1).Remove the battery compartment cover.

2).Insert batteries. Follow the diagram inside the battery compartment.

3).Replace cover.

2. Connect the Receiver

For USB-port installation (Windows 98 or higher required, or Macintosh OS

8.6 or higher required), connect the receiver cable to the USB port on your
computer. For Windows 98, you may be prompted to insert the Windows
software CD. Insert this CD into the CD-ROM drive, then follow the
on-screen instructions.

3. Making a connection between hand track and receiver

Press the ID connect button on the Receiver, then press the Red connect
button on the hand track to transfer the signal to the receiver.

4. Recharging your battery

Your RF Hand Track has a function for recharging battery. This function can be
used on the rechargeable battery only. Any other type of battery is not suitable
for this function. Refer to the following steps to re-charge your NiMH
rechargeable battery.

1).Load in your NiMH rechargeable batteries according to the diagram inside
the battery compartment.

2). Connect the power cable on the bottoms of both hand track and receiver

3). You can operate the RF Hand Track as normal while the batteries are in
charging.

1

European Statement

Hereby, 3G GREEN GREEN BLOBE CO., LTD., declares that this Laser Scanner is in
compliance with the essential requirements and other relevant p rovi sion s of the R&TTE
Directive 1999/5/EC.
This device will be sold in the following EEA countries: Austria, Italy. Belgium, Liechtenstein.
Denmark, Luxembourg. Finland, Netherlands. France, Norway. Germany, Portugal. Greece,
Spain. Iceland, Sweden. Ireland, United Kingdom.

FEDERAL COMMUNICATIONS COMMISSION

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.

This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure
limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal
operation.