CPE INSTALLATION
AND
USER GUIDE
Gen6 CPE – model 2X
Version 3 Users and Installation Manual
This guide covers the assembly and configuration of the 2xWireless CPE equipment.
Introduction
The 2xWireless customer premise equipment (CPE) wireless device is a high performing, all outdoor
device designed to provide high capacity data transfer, low latency and low jitter. The 2xWireless CPE
provides a full duplex wireless connection utilizing a patent pending Frequency Division Duplex – Time
Division Duplexing FDD-TDD 802.11 protocol capable of connection distances up to 25 miles. The
protocols used in the CPE deliver latency of less than 1ms, over 1 million packets per second, and up to
40 Mbps of data. Designed with performance in mind, 2xWireless CPE’s provide end users with
increased throughput, better reliability, and a higher quality solution than many of the other wireless
solutions on the market today. 2xWireless’ CPE’s are an easily deployed, affordable last mile solution for
service providers.
Contents
Each 2xWireless CPE kit comes with the following components. Shielded Ethernet cable and grounding
cable are not included in the CPE package. Remove all parts from packaging and inspect for damage and
missing parts before beginning assembly.
Qty - Description
A (1) 16” Dish
B (1) Radio Unit
C (1) Mounting Bracket 1
D (1) Mounting Bracket 2
E (2) Steel Tooth Bracket
F (4) 10-24 Phillips Machine Screws
G (1) Power Supply
H (1) Ethernet Patch Cable
Qty - Description
I (2) V-Bolts
J (4) ¼”-20 Serrated Flange Nuts
K (8) ¼”-20 Carriage Bolts
L (8) ¼”-20 Hex Nuts
M (8) ¼” Lock Washers
N (8) ¼” Flat Washers
O (1) Surge Suppressor
CPE Assembly Instructions
Assembly of the mounting bracket
1. Insert both V-bolts through the inside of mounting bracket 1. The completed step should look
like this.
2. Insert (4) of the 1” carriage bolts through the flat side of mounting bracket 2 as shown. Seat the
base of the carriage bolt into the square hole in the bracket. Place the 2 halves of the bracket
together, the larger end of bracket A should be facing downwards. Bolt plastic brackets together
using (4) flat washers, (4) lock washers, and (4) ¼”-20 hex nuts. Finger tighten only. These bolts
will be tightened during installation and adjustment. Set the assembly aside.
Loading...