2N 2Wire User Manual

9159014
2N® 2Wire
2N® 2Wire
Power
Ethernet ­Data
2 wires
Ethernet –
Data and PoE
2N® 2Wire
Product features
- Using legacy analog 2 wire cabling for IP intercom connection
- Saves cost for UTP cabling and makes possible to install IP
intercoms on legacy infrastructure
- Alternatively one master unit can support up to four slaves
- Long range Ethernet extension over 2 wires or coax
- IEEE 802.3 af/at Compliant 40 Watt PoE+ for IP intercom power
supply
- Easy configuration, no IP address and network setup required,
plug&play
- Calculated MTBF = 340,000 hours
Includes
- 2pcs converter unit with Coax / 2 wire adaptor
- 1pc power supply adaptor
Product use
- Install master unit where your ethernet cable ends and 2 cable
wiring begins.
- Plug in Ethernet and 2 cable wiring into 2N® 2Wire.
- Install slave unit where you need convert 2 cable wiring back to
Ethernet at remote location. Please observe polarity of the 2 wires.
- Connect provided power supply to master unit.
- Any of the units can be master or slave. Master unit is the one with
connected power supply, while slave is powered via 2 wires
- Blue Power LED indicators should indicate that both units are
powered
- Both BNC and PoE green LED should be blinking, thus signalling
established connection and data transmission.
Ethernet Interface
2N TELEKOMUNIKACE a.s. Modřanská 621, 143 01 Praha 4, Czech Republic www.2n.cz
RUx v1
- Connector Type : RJ45
- Speed : 10/100 Base T, half/full duplex, auto-negotiation
- IEEE 802.3 af/at 40Watt Compliant PoE+
Extended Wiring Interface (2 wire/coax)
- Cable Type : 2Wire, Cat 5e., Cat 6. or Similar
- Impedance : 25Ω to 100Ω
- Transmit Coverage : Typical 720ft (220m) @ Cat6 with PoE at far end; up to 2460ft (750m) possible; depends on wiring and interference
Transmission Method
- Access Method : CSMA/CA and TDMA
- Modulation Method : Windowed OFDM
- Frequency band : 1.8MHz to 30MHz
LED Indicators
- Power : Blue – Power ON
- BNC : Green – Link ON
- PoE : Green – Link ON
AC/DC Power Supply (provided)
- Input AC : 100 ~ 240VAC , 50~60 Hz
- Output DC : 48VDC / 0.84A ~ 1.25A
Dimension of one unit
- 1.57x1.57x2.95in., 40x40x75mm (HxWxL)
- Weight : 4.2oz (120g)
- Material : Extruded Aluminum
Environmental
- Operating Temperature : 14°F to 122°F (-10°C to +50°C)
- Storage Temperature : -22°F to 158°F (-30°C to +70°C)
EC Declaration of Conformity
Hereby, 2N TELEKOMUNIKACE a.s., declares that the 2N® 2Wire product is in compliance with the essential requirements and other relevant provisions of Directive 2004/108/EC. Refer to our website www.2n.cz for the Declaration of conformity.
Loading...