2N 2ENTRY Helios User Manual

2ENTRY Helios color video camera kit

Order No. 9135210E

Description

The 2ENTRY Helios color video camera kit contains all necessary items for additional

upgrade of your door communicator. It contains an electronic camera module, movable hinge
and the connection cable for the camera and the communicator’s main board. The video
camera is adjustable both vertically and horizontally due to the movable hinge system. In order
to configure the camera use the appropriate connectors (jumpers) provided in the kit.

!!Warning!!

The video camera shares the power supply with the back light. Before installation make sure
that the parameters of the back light power supply comply with the requirement of the video
camera (see “Technical Parameters” section in the manual). The suitable power supply is
12V/2A stabilized. It is possible to order this power supply by using order number 91341481E.

In no case use AC power supply (mains transformer)!

Installation

1. Remove metal cover from the door phone.
Remove plastic cover from the base by
unscrewing the screws (4x) located at the
corners.

2. Remove the black camera cover and replace it
with the clear cover from the “video kit”.

3. Remove the loudspeaker cradle from the base
by lifting out the pins and pushing the cradle
slightly forward.

4. Assemble the movable hinge and screw (2x) it
to the base. Place the video camera on the top
of the hinge and use provided screws (2x) to
secure (see the figure below).

5. Connect the camera with the main board using the provided cable.

6. Select the camera mode
and video cable type via
jumpers. In the "Video
on during call“ mode,
the output is active
when a call is being
made to/from Helios.
When the call is
terminated, the video
remains active for about
7 seconds and then
switches off. Select the

"Permanently on"
mode for outdoor installations to avoid camera damage by air humidity. It is

because the camera is heated during operation and thus no moisture condensation can
occur.

7. Connect a video cable to the Video Output terminals on
the main board. If you use a twisted pair instead of
coax cable, it is not relevant which conductor leads to
which terminal but you are advised to record the
arrangement (+ / - mark, conductor colour). You will
use this information while installing the LCD monitor or
video server on the other cable end. If you use a coax
cable, connect its live wire to the + terminal and the
shield to the - terminal. If you use a UTP cable, connect the video signal to such two
conductors that are twisted together (making a twisted pair), never use two arbitrary
conductors. By connecting or disconnecting the jumper set the impedance match of the
video output for the coax cable or twisted pair.

8. Adjust the camera to desired viewing angle.

9. Insert cradle with the speaker back into the main board. Make sure that the cradle fits
properly in the appropriate holes.

10. Reassemble the door phone by mounting the plastic cover to the base and secure with
screws (4x) as well as placing back the metal cover.

Technical Parameters

Supply voltage stabilised 11,6 – 12,6Vdc, common supply to camera and button backlight
Current consumption 130mA
Video modes permanently on / on during call / permanently off
Video output colour composite PAL video signal, 1Vpp
Video output matching
Resolution 420 TV rows
Sensitivity 2 lux
Function in darkness yes, black&white mode, illumination by white and infrared LEDs under name plates
Camera turning option horizontally and vertically in the range of ± 8º
Camera chip colo ur, 1/3" CCD, automatic transition to black&white mode at dark
Camera objective pinhole type, f = 3.7mm
Camera angle of view 90º diagonally
Max. cable length 100m

75Ω coaxial cable/ twisted pair of UTP category 5 and higher

© 2006, 2N TELEKOMUNIKACE a.s. - Praha OV 1290 v.1