Texas Instruments 900 Series User Manual
603.53 Kb

Extensa™ 900 Series

Notebook Computers

User’s Guide


Copyright © 1996 Texas Instruments All Rights Reserved — Printed in Taiwan

Extensa™ 900 Series Notebook Computer User’s Guide

TI Part No. 9813630-0001

Original Issue: September 1996

First Revision: November 1996

Changes may be made periodically to the information in this publication. Such changes will be incorporated in new editions of this manual.

Record the serial number, purchase date, and model number in the space provided below. The serial number and model number are recorded on the label affixed to the case. All correspondence concerning your unit should include the serial number, model number, and date of purchase.

No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopy, recording, or otherwise, without the prior written permission of Texas Instruments.

Extensa Notebook Computer

Model_______Serial No.____________Purchase Date________


Extensa and livegear are trademarks of Texas Instruments. The icons in the Windows Notebook and Startup groups are copyrighted by Texas Instruments.

AT and PS/2 are registered trademarks and OS/2 is a trademark of International Business Machines Corporation.

Microsoft, MS-DOS,Windows and Xenix are registered trademarks of Microsoft Corporation.

Kensington is a registered trademark of Kensington Microware, Inc.

Synaptics is registered trademark of Synaptics, Inc. SimulSCAN is a trademark of Cirrus Logic, Inc. IrDA is a trademark of Infra Red Data Association.

Phillips is a registered trademark of H.A. Phillips & Co.


This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

nReorient or relocate the receiving antenna

nIncrease the separation between the device and receiver

nConnect the device into an outlet on a circuit different from that to which the receiver is connected

nConsult the dealer or an experienced radio/television technician for help

Notice: Shield Cables

All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations.

Notice: Peripheral Devices

Only peripherals (input/output devices, terminals, printers, etc.) certified to comply with the Class B limits may be attached to this equipment. Operation with non-certifiedperipherals is likely to result in interference to radio and TV reception.


Changes or modifications not expressly approved by the manufacturer could void the user’s authority, which is granted by the Federal Communications Commission, to operate this computer.

FCC Notice

Use Conditions

This part complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Notice: Canadian Users

This Class B digital apparatus meets all requirements of the Canadian Interference-CausingEquipment Regulations.

Remarque à l’intention des utilisateurs canadiens

Cet appareil numérique de la classe B respected toutes les exigences du Règlement sur le matériel brouilleur du Canada.