Havis-Shields C-VS-1200-EXPD-1 User Manual
4
INSTALL INSTRUCTIONS C-VS-1200-EXPD-1
VEHICLE SPECIFIC CONSOLE
2007-2008 FORD EXPEDITION (w/ Console shifter)
TOOLS REQUIRED:
Ratcheting wrench
Sockets Set
Panel pulling tool
HARDWARE:
DESCRIPTION PART #
QTY
4 #10 x ½” Phillips machine screw GSM33118
4 #10 Keps nut GSM30028
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html
Screwdriver set
T-20 torx bit
C-VS-1200-EXPD-1
Front
#10 x ½” Machine
screws and keps nuts
Rear
View of vehicle w/ full console
& console shifter
Remove hex head screw from
accessory pocket
Remove accessory pocket liner
as shown above
CAREFULLY remove trim
from around gear shifter
Remove trim from around the
cup holders
Remove trim panel from
console.
View of panel removed
2
Remove hex head screw from
accessory pocket/armrest
C-VS-1200-EXPD-1_INST_9-07
Loading...