2277 Harbor Bay Pkwy
Alameda, CA 94502 1.888.880.8368
RC-0001 DCBL Remote Installation Instructions
! CAUTION: Hood must be disconnected from main power prior to performing the conversion instructions listed below. Failure to do so could result in personal injury or damage the hood.
|
|
|
1. Locate Main PC Board on top of blower |
Inclided Materials: 1 Remote Module w/antenna |
|||
wire, 1 Remote control, 1 Remote control holder, |
housing of hood body. Remove (4) Main |
||
1 battery, 2 screws. |
PC Board cover screws. |
||
|
|
|
A |
|
B |
2. Remove Main PC Board from PC Board box. Use |
3. Disconnect black switch cable A from Main PC |
board and connect it to the Remote Module terminal. |
|
caution when removing Main PC Board as to not |
Connect white cable B from Remote Module to Main |
disconnect any wires |
PC board switch terminal. |
4. Install Remote Module into Main PC Board box by (2) screws.
5. Re-install Main PC Board into PC Board box. Be sure blue antenna wire from Remote Module is outside of PC Board box. Turn to page
2 for remote synchronization & features.
Page 1