Zephyr Z1C-00TI, Z1C-01TI User Manual
Loading...
customer service 1.888.880.8368
Duct Cover Short/Long
Z1C-00TI
Z1C-01TI
For use with Tilt range hood
|
|
Mounting the duct cover |
Pag. 3 |
|
|
|
|
|
|
|
|
Fixation des cheminees |
Pag. 4 |
|
|
|
|
|
|
|
|
Fijación de las chimeneas |
Pag. 5 |
|
|
|
|
|
|
|
|
Fissaggio dei camini |
Pag. 6 |
|
|
|
|
||
|
|
|
||
|
|
|
|
|
www.zephyronline.com
DUCT COVER EXTENSION SPECIFICATION
|
|
1 |
Longer size: Min 51" - Max 85" |
Standard size: Min 35" - Max 52" |
11/16" |
|
|
16- |
|
|
|
19-1/4" |
13-7/8" |
10-1/16" |
° 130
- 2 -
MOUNTING THE DUCT COVER
1. Open the front panel. Fig.1
NOTE! Open the front panel while holding it by its external sides, as shown in Fig.1, and keep at a suitable distance to avoid impacting it.
2.Remove the Decorative Mesh Filters.
3.Loosen the two screws inside the hood that fasten the canopy. Fig.2
4.Slide the top cover off by lifting it. Fig.3
5.Adjust the width of the duct cover support bracket so that it fits inside the top of the chimney and observing the distance shown in Fig. 4
6.Secure duct cover bracket to top of wall just below the ceiling using (2) screws provided. See Fig.5
7.Place correct size ducting for your installation (not supplied) to the hood and secure to the blower collar with aluminum duct tape. Fig. 6
8.Insert top duct cover into bottom duct cover. Seat the duct covers correctly on the hood.
9.Extend top duct cover up and secure to the duct cover bracket using (2) screws. See Fig. 7
- 3 - |
Installation - Mounting the Duct Cover