Zephyr PRW24F02BG Manual

Loading...

www.zephyronline.com

Use, Care and Installation Guide

PRW24F02BG

Presrv Full Size Dual Zone Wine Cooler

FEB20.0201

1

Table of Contents

 

Page

Safety Information

3-8

Introduction

9

Specifications

10

Storage

10

Parts Identification & Dimensions

11

Installation Instructions

12-17

Operating Your Appliance

18-19

Care and Maintenance

20-21

List of Materials

21

Troubleshooting

22-23

Product Registration

24

Warranty

25

2

Safety Information

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual for your appliance. Always read and obey all safety messages.

This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can cause severe bodily injury or death. All safety messages will follow the Safety Alert Symbol and either the words “DANGER” “WARNING” or “CAUTION”

Danger means that failure to heed this safety statement may result in severe injury or death.

Warning means that failure to heed this safety statement may result in extensive product damage, serious personal injury, or death.

Caution means that failure to heed this safety statement may result in minor or moderate personal injury, property or equipment damage.

3

Safety Information

For your safety, read all instructions carefully before operating the appliance.

DANGER: When using an electrical appliance, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons.

WARNING: To reduce the risk of fire, electric shock or personal injury, unplug or disconnect the appliance from the power supply before servicing.

CAUTION: Flammable refrigerant used! When handling, moving and use of the refrigerator, make sure to avoid either damaging the refrigerant tubing, or increasing the risk of a leak.

Use this appliance only as described in this manual. Other uses not recommended may cause fire, electric shock or personal injury.

This appliance is not intended for use by young children or infirm persons unless they have been adequately supervised by a responsible person to ensure that they can use the appliance safely.

Young children should be supervised to ensure that they never play with the appliance.

To protect against the risk of electric shock, NEVER IMMERSE the unit, cord, or plug in water or spray any other liquid.

Unplug the appliance from the plug socket when not in use, when moving from one location to another and before cleaning.

To disconnect the appliance, grip the plug and pull it from the wall outlet. Never pull by the cord.

Never operate the appliance in the presence of explosive and/or flammable fumes.

Never place the appliance or any of its parts near an open flame, cooking or other heating appliance.

Never operate the appliance with a damaged cord or plug, if the product malfunctions, or if it is dropped or damaged in any manner.

The use of attachments not recommended by the manufacturer may be hazardous.

Never operate if the housing is removed or damaged.

A loose fit between the AC outlet (receptacle) and plug may cause overheating and a distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.

Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).

4

Safety Information

WARNING: Prop. 65 Warning for California Residents: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.

This appliance is CFC and HFC free and contains small quantities of Isobutane (R600a), an environmentally friendly coolant.

You must ensure that the cooling circuit is undamaged when installing the appliance. However, if it becomes damaged, avoid proximity to open fires and heat sources of all kinds. The room in which the appliance is located should be ventilated properly and according to state and local codes.

Never use an appliance with a damaged circuit.

Ensure that the ventilation openings to and from a built-in appliance are never blocked or covered.

No liability will be accepted for any damage caused by misuse of the appliance, or as a result of repairs carried out by unqualified person. In this case neither the warranty nor any other liability claims will apply.

WARNING: Never operate any other electrical appliance inside this appliance.

Never attempt to repair or replace any part of your appliance unless it is specifically recommended in this manual. All other servicing should be referred to a qualified technician.

Replace all access panels before operating.

Use two or more people to move and install the appliance. Failure to do so can result in back or other injury.

Never clean appliance parts with flammable liquids. These fumes can create a fire hazard or explosion. Never store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. The fumes can create a fire hazard or explosion.

Never connect or disconnect the electric plug with wet hands.

It is recommended that a separate circuit, serving only your appliance be provided. Use receptacles that cannot be turned off by a switch or pull chain.

5

Safety Information

WARNING: To reduce the risk of fire, electric shock or personal injury, unplug or disconnect the appliance from the power supply before servicing.

Save These Instructions

If you are experiencing problems, check the Troubleshooting Guide at the back of this manual. It lists causes of minor operating problems that you can correct yourself.

Disposal of Old Appliance

Dispose of your appliance packaging properly.

Refrigeration equipment must be properly disposed of in a way which protects the environment. This applies to your old appliance and to your new unit once it has reached the end of its service life.

WARNING: Please ensure that old, worn appliances are rendered unusable before disposal by removing the plug, cutting the power cable, and removing or destroying any snap fastenings or bolts. You will thus prevent children from locking themselves in the appliance during play (risk of suffocation) or endangering their lives in any other way.

Disposal instructions:

The appliance must not be disposed with normal household waste collection.

The coolant circuit, particularly the heat exchange at the back/bottom of the unit, must not be damaged.

The symbol on the product or its packaging indicates that this product is not to be handled as normal household waste but is to be taken to a recycling collection point for electrical and electronic goods. By correctly disposing of this product you are contributing to the protection of the environment. Improper disposal endangers health and the environment. Further information about the recycling of the product may be obtained from your town hall or local waste collection department.

6

Safety Information

Before Using Your Appliance

Remove all exterior and interior packing.

Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system caused by handling during transportation.

Clean the interior surface with warm water using a soft cloth.

The door on this appliance can be opened from either the left or the right side. The unit is delivered with the door opening on the left side. Should you wish to open the door from the right, follow the instructions, “Reversing the Door Swing of your Appliance,” listed below.

Installation of Your Appliance

The appliances are designed for either built-in, or free-standing installation.

WARNING: Do not store or install the appliance outdoors.

Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level your appliance, adjust the 4 legs until level.

Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.

Never place the unit in damp areas.

Plug the appliance into an exclusive, easily accessible electrical socket.

Any questions concerning power and/or electrical connection should be directed towards a qualified electrician or an authorized products service center.

The air vent at the front of the appliance must never be covered or blocked in any way.

The appliance must be installed to all electrical connections in accordance with state and local codes.

Use two or more people to move and install the wine cooler. Failure to do so can result in back or other injury.

The cooler may experience decreased cooling efficiency if air flow is restricted due to a fully loaded cabinet.

Install the wine cooler in a well-ventilated area where the ambient temperature is above 50ºF and below 90ºF.

7

Safety Information

Attention

Never overload the cabinet.

Never open the door unless necessary.

Never cover shelves with aluminum foil or any other shelf material which may prevent air circulation.

Should the appliance be left empty for long periods, it is suggested that the appliance be unplugged, and, after careful cleaning, leave the door ajar to allow air to circulate inside the cabinet in order to avoid possible condensation, mold or odors from forming.

Electrical Connection

Check that the voltage marked on the product corresponds with your supply voltage.

WARNING: Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by a qualified electrician or an authorized service center.

This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-pin plug which mates with standard three-pin wall outlets to minimize the possibility of electrical shock.

Never under any circumstances cut or remove the third ground prong from the power cord supplied. For personal safety, this appliance must be properly grounded.

Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard two-pin wall outlet is encountered, it is your responsibility and obligation to have it replaced with a properly grounded threepin wall outlet.

To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or dangling.

The appliance should always be plugged into its own individual electrical outlet which has a voltage rating that matches the rating label on the appliance. This provides the best performance and also prevent overloading wiring circuits that could cause a fire hazard from overheating. Never unplug the appliance by pulling the power cord.

Always grip the plug firmly and pull straight out from the receptacle. Repair or replace immediately all power cords that have become frayed or otherwise damaged. Never use a cord that shows cracks or abrasion damage along its length or at either end. When moving the appliance, be careful not to damage the power cord.

Never use your appliance with an extension cord unless this cord has been checked and tested by a qualified technician or service person. The extension cord must be a UL/CUL Listed, 3-wire grounding extension cord that has a grounding plug and outlet and that the electrical rating of the cord is 115 volts and at least 10 amperes.

8

Introduction

Thank you for purchasing your Zephyr wine cooler. Zephyr is dedicated to developing products that will enhance your lifestyle with superior quality and distinctive features. Please visit www.zephyronline.com for more information on your product and other Zephyr products.

This manual contains important information regarding the proper installation, use, and maintenance of your wine cooler. Following this manual will ensure that your product will work at its peak performance and efficiency.

For Your Records:

Please write down the model number and serial number below for future reference. Both numbers are located on the rating label on the back of your unit and are needed to obtain warranty service. You may also want to staple your receipt to this manual as it is the proof of your purchase and may also be needed for service under warranty.

Model Number:

Serial Number: Date of Purchase:

To better serve you, please do the following before contacting customer service:

If you received a damaged product, immediately contact the retailer or dealer that sold you the product.

Read and follow this instruction manual carefully to help you install, use and maintain your wine cooler.

Read the troubleshooting section of this manual as it will help you diagnose and solve common issues.

Visit us on the web at http://www.zephyronline.com to download product guides, additional troubleshooting resources and up-to-date information.

If you need warranty service, our friendly customer service representatives are available on our website at http://zephyronline.com/contact or by telephone at 888-880-8368.

9

Specifications

This appliance requires a standard 115/120 Volt AC~60Hz electrical ground outlet

DESCRIPTION OF PRODUCT

Presrv Full Size Dual Zone

 

Wine Cooler

MODEL

PRW24F02BG

VOLTAGE/FREQUENCY

AC 115/60Hz

AMPERAGE

2.5 A

COLOR

Black Cabinet with Stainless

 

Steel Door

STORAGE CAPACITY

(138) 750ml bottles

REFRIGERANT

R600a

TEMPERATURE RANGE – Zone 1

40° - 65° F

and Zone 2

 

DIMENSIONS (HxWxD)

69-5/8’’ X 23-7/8’’ X 27-1/2’’

 

 

GROSS WEIGHT (lb)

297.6 lb

OPTIONAL PRO HANDLE

PRHAN-F001

ACCESSORY

 

OPTIONAL DISPLAY RACK

PRDISP-F001

REPLACEMENT CARBON FILTER

Z0F-C004

Internal Storage

10

Parts Identification & Dimensions

11

Installation Instructions

Carbon Filter

A built-in carbon filter protects your wine by acting as a natural barrier against harmful odors. The carbon filter should be replaced every 3-6 months depending on the unit’s exposure level to odor. If the unit is placed in a kitchen, regular replacement every three months is ideal.

Remove the carbon filter by turning counterclockwise to unlock from rear panel.

Carbon Filter Replacement Part #: Z0F-C004

Installation Clearance Requirements

When installing the wine cooler under a counter, follow the recommended spacing dimensions shown.

To ensure proper service access and ventilation, allow at least 1” of clearance at the back as shown in the diagram.

The installation should allow the unit to be pulled forward for servicing, if necessary.

The power cable is located on the back right of the unit and has a length of 72” to accommodate multiple outlet locations.

An installation next to a wall will require a minimum 2-1/4” door clearance to accommodate the handle.

12

Installation Instructions

Installation Clearance Requirements cont.

When installing the wine cooler under a counter, follow the recommended spacing dimensions shown.

The cabinet should allow at least 24” for the width and 69-3/4” for the height to accommodate the wine cooler.

Once you are ready to install the unit in a cabinet or directly on the floor, you must adjust the feet to level the wine cooler.

13

Installation Instructions

Reversing the Door Swing of Your Appliance

Should you desire to reverse the opening direction of the door, please follow the instructions below. Safely reversing the door swing of your application should require at least two people.

1.Open the door and using a Phillips screwdriver, remove the bottom screws from the lower hinge.

2.Pull down to remove the glass door and place it on a padded surface to prevent scratching it.

3.The door revolves 180 degrees. Remove the door magnet and install it on the opposite side.

4.Remove the screws from the upper right hinge. Place the upper right hinge in a safe place in case you need to reverse the door in the future. Remove the decorative covers from the upper left hinge corner. Install the upper left hinge by fastening the screws through the left hinge to the cabinet. Insert the decorative covers to the upper right hinge.

5.Remove the door axis from the lower right hinge. Install the door axis on the lower left hinge.

6.Carefully insert the door into the upper left hinge, then slide the door on top of the lower hinge and secure the door by installing the lower screws.

14

Installation Instructions

Installing the Anti-tip Bracket

1.Position anti-tip bracket at a minimum of 8” from the left or right of the side of the cooler.

2.Install anti-tip bracket to floor by using supplied 2” screws.

3.Push the cooler back into anti-tip bracket making sure the bracket overlaps the cooler bottom.

Installing the Handle

1.Push aside the door gasket on the side you wish to install the handle. Under the gasket you will see two designated holes for handle installation and pre-installed screws.

2.Install the handle tightly as shown with two screws, lock washers and flat washers pre-installed.

15

+ 35 hidden pages