ZALMAN 9500 User Manual

ZALMAN 9500 User Manual

User s Manual

(English version)


1)100% copper heatsink with aerodynamically optimized “tunnel” design for maximum cooling efficiency.

2)Innovative and patented, curved heatpipe design for a heat transfer capacity of up to 6 heatpipes with just 3.

3)Optimized heatsink layout for maximum cooling efficiency with minimal materials.

4)0.2mm ultra-slim fins for minimized weight and reduced airflow resistance.

5)Ultra quiet CNPS 92mm opaque fan with blue LEDs.

6)Aerodynamically optimized heatsink for smoother airflow and minimal noise.

7)Compatible CPUs (Refer to “7. Compatible CPUs” on page 3. for more information.)

-Intel : All Dual Core Pentium CPUs (Socket 775)

All Pentium 4 CPUs (Socket 775/478)

- AMD :All Dual Core AMD Athlon 64 X2 CPUs (Socket 939) All AMD Sempron/AMD64 CPUs (Socket 754/939/940)

8) Adjustable fan speed controller (FAN MATE 2) enables control of noise and fan speed.







:1,350RPM 10 % (Silent Mode) 2,600RPM 10 % (Low-noise Mode)

10% (Silent Mode) - measured at 1m from noise source 10% (Low-noise mode) - measured at 1m from noise source

5V ~ 11V 2 % : 6W or lower

weight for a cooler is specified as 450g for Intel Socket 775 and AMD Socket

. Special care should be taken when moving a computer equipped with a cooler the specified weight limit. Zalman is not responsible for any damage that occurs a computer.

Fixing Bolt

Heat sink


CPU Block Fixing Bolt



No. 05-45737

Applications No. 05-15303, 15304, 15306, 15307, 17970, 17971

pending in over 20 nations around the world including USA, EU, and Japan


on the fan, it may result in malfunction or damage to the product and/or the

the fan while spinning.

from the reach of children and pets.

and condition of the product before installation. If any problem is found, contact obtain a replacement/refund.

for any damages arising from using the product outside of its intended

may become damaged if the product is incorrectly installed. the “Installation” steps before installing the product.





installing the Cooler)

2) Components for Intel Pentium 4 (Socket 478)

Two(2) Clip Supports for Socket 478

Two(2) Installation Bolts for Socket 478

One(1) L-Wrench

3) Components for Intel Dual Core Pentium / Pentium 4 (Socket 775)

Four(4) Clip Support Fixing Bolts for

Socket 775

One(1) Clip Support for Socket 775

One(1) Backplate for Socket 775

4) Components for AMD Sempron/AMD64 (Socket 754/939/940)

Two(2) Nipples


+ 6 hidden pages