Yamaha HTR 5063, RX-V467, HTR-4063, RX-V567 User Manual

4 (1)

Firmware Update Procedure for RX-V467/RX-V567

September, 2010

Subject: RX-V467/RX-V567 Firmware Update Version F018

(Including HTR-4063/HTR-5063)

Yamaha is pleased to offer the following firmware update to ensure the best possible

performance and features for your Yamaha RX-V467/RX-V567 AV Receiver. This firmware adds 3D video pass-through capability for the HDMI connections and improves stability with 3D signals from DirecTV set-top boxes.

Requirements:

A personal computer capable of burning an audio CD

BD/DVD/CD player* with digital audio connection

(Optical or Coaxial, not HDMI) *Note

CD PLAYER IS PREFERRED.

Some DVD players use digital filters, which affects the output signal of the devices. This firmware update may not work with DVD players which use these digital filters. CD players usually do not use these filters.

CHECK THE UNIT’S FIRMWARE VERSION PRIOR TO THIS UPDATE

The firmware version consists of a letter followed by three numbers [ex. “F018”].

If the three numbers in the firmware version are 018 or higher, you DO NOT need to perform this update.

How to check your firmware version:

Press and hold the [STRAIGHT] button on the front panel and keep it pressed while you press the [STANDBY/ON] button. Once the front panel displays "ADVANCED SETUP", release the [STRAIGHT] button. Then, press and hold the [TONE CONTROL] button for about 3 seconds until front panel display shows the firmware version.

The following pages contain the firmware update instructions for Yamaha AV receivers RX-V467/V567. The outline of the update is as follows:

1.Create an update disc (Audio CD)

2.Connect digital audio with CD, DVD or BD player

3.Enter firmware update mode

4.Play the update disc (Reprogramming)

5.Confirm update firmware version

<IMPORTANT NOTICE >

Do not attempt to update your Yamaha receiver using any other data file except those provided directly from the Yamaha website.

Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by Yamaha.

Improperly updated products may cause improper operation, and any parts or service required to restore proper operation will not be covered under the Yamaha Limited Warranty.

Page.1 of 5 Sep

Yamaha HTR 5063, RX-V467, HTR-4063, RX-V567 User Manual

Firmware Update Procedure for RX-V467/RX-V567

Instructions for Firmware Update:

STEP1 CREATE UPDATE DISC

Download the firmware from YAMAHA website.

Unzip and burn the WAV file onto CD-R/RW as an Audio-CD. This will be your update disc.

If you need instructions on creating this firmware update CD, see your Personal Computer ("PC") CD burning software instructions on how to burn WAV file as an Audio CD.

Note:

Conventional CD burning software is recommended. An audio CD burned by Windows Media Player may not work.

STEP2 CONNECT DIGITAL AUDIO WITH BD/DVD/CD PLAYER

Unplug the AC power cable of the receiver from the wall outlet and turn off the power of BD/DVD/CD player. Then, connect CD DVD or BD player* using digital connection (Coaxial or Optical) into any input of your receiver.

<Connection with OPTICAL cable>

<Connection with COAXIAL cable>

*Some DVD players use digital filters, which affects the output signal of the devices. The firmware update will not work with DVD players which use these digital filters. CD players usually do not use these filters, so using a CD player is preferred.

Picture shows an example of the connection. Depending on your

BD/DVD/CD player's digital output, connect the receiver with either optical or coaxial.

Page.2 of 5

Loading...
+ 3 hidden pages