B G R T
AX-392
Natural Sound Stereo Integrated Amplifier
Préampli/ampli de puissance stéréo de la série “Natural Sound”
Natural Sound Stereo-Verstärker
Natural Sound Integrerad Stereo Förstärkare
Amplificatore integrato stereo a Suono Naturale
Amplificador integrado estéreo de Sonido Natural
Natural Sound Geïntegreerde Stereo Versterker
OWNER’S MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI
MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING
SUPPLIED ACCESSORIES ACCESSOIRES FOURNIS MITGELIEFERTES ZUBEHÖR MEDFÖLJANDE TILLBEHÖR ACCESSORI IN DOTAZIONE ACCESORIOS INCLUIDOS BIJGELEVERDE ACCESSOIRES
●After unpacking, check that the following parts are contained.
●Après le déballage, vérifier que les pièces suivantes sont incluses.
●Nach dem Auspacken überprüfen, ob die folgenden Teile vorhanden sind.
●Kontrollera efter det apparaten packats upp att följande delar finns med.
●Verificare che tutte le parti seguenti siano contenute nell’imballaggio dell’apparecchio.
●Desembale el aparato y verificar que los siguientes accesorios están en la caja.
●Controleer na het uitpakken of de volgende onderdelen voorhanden zijn.
● |
Remote Control Transmitter |
● |
Batteries (size AA, R6, UM-3) |
● |
Emetteur de télécommande |
● |
Piles (taille AA, R6, UM-3) |
● |
Fernbedienung |
● |
Batterien (Größe AA, R6, UM-3) |
● |
Fjärrkontroll |
● |
Batterier (storlek AA, R6, UM-3) |
● |
Telecomando |
● |
Batterie (dimensioni AA, R6, UM-3) |
● |
Transmisor del control remoto |
● |
Pilas (tamaño AA, R6, UM-3) |
● |
Afstandbediening |
● |
Batterijen (maat AA, R6, UM-3) |
YAMAHA HiFi SYSTEM
REMOTE CONTROL TRANSMITTER
AUX
DIR A DIR B REC/PAUSE PLAY MD
A/B TAPE
– PRESET + A/B/C/D/E |
TUNER |
|
DISC |
PLAY |
CD |
|
|
PHONO |
POWER |
VOLUME |
|
SLEEP |
|
|
2
Thank you for selecting this YAMAHA stereo amplifier.
FEATURES
●60W + 60W (8Ω ) RMS Output Power, 0.04% THD, 20–20,000 Hz
●High Dynamic Power, Low Impedance Drive Capability
●Continuously Variable LOUDNESS Control
●CD DIRECT AMP Switch to Reproduce the Purest CD Sound
●Remote Control Capability
English
CONTENTS |
|
SUPPLIED ACCESSORIES .............................................................................. |
2 |
FEATURES ......................................................................................................... |
3 |
CAUTION ........................................................................................................... |
4 |
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER ............................ |
5 |
CONNECTIONS ................................................................................................ |
6 |
CONTROLS AND THEIR FUNCTIONS ............................................................. |
8 |
OPERATIONS .................................................................................................. |
11 |
TROUBLESHOOTING ..................................................................................... |
14 |
SPECIFICATIONS ........................................................................................... |
15 |
3
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.
1.To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.
2.Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the unit to rain or water.
This unit is not disconnected from the AC power source as long as it is connected to the wall outlet, even if this unit itself is turned off. This state is called the standby mode. In this state, this unit is designed to consume a very small quantity of power.
3.Never open the cabinet. If something drops into the set, contact your dealer.
4.Do not use force on switches, controls or connection wires. When moving the unit, first disconnect the power plug and the wires connected to other equipment. Never pull the wires themselves.
5.The openings on the cabinet assure proper ventilation of the unit. If these openings are obstructed, the temperature inside the cabinet will rise rapidly. Therefore, avoid placing objects against these openings, and install the unit in wellventilated condition. Be sure to allow a space of at least 10 cm behind, 10 cm on the both sides and 20 cm above the top panel of the unit. Otherwise it may not only damage the unit, but also cause fire.
6.Always set the VOLUME control to “–∞ ” before starting the audio source play: increase the volume gradually to an appropriate level after the play has been started.
7.Do not attempt to clean the unit with chemical solvents; this might damage the finish. Use a clean, dry cloth.
8.Be sure to read the “TROUBLESHOOTING” section regarding common operating errors before concluding that the unit is faulty.
9.When not planning to use this unit for long periods of time (ie., vacation, etc.), disconnect the AC power plug from the wall outlet.
10.To prevent lightning damage, disconnect the AC power plug and antenna cable when there is an electrical storm.
11.Grounding or polarization – Precautions should be taken so that the grounding or polarization of an appliance is not defeated.
12.Do not connect audio equipment to the AC outlet on the rear panel if the equipment requires more power than the outlet is rated to provide.
13.Voltage Selector (China and General Models only)
The voltage selector on the rear panel of this unit must be set for your local main voltage BEFORE plugging into the AC main supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
IMPORTANT
Please record the serial number of this unit in the space below.
Model:
Serial No.:
The serial number is located on the rear of the unit. Retain this Owner’s Manual in a safe place for future reference.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
For U.K. customers
If the socket outlets in the home are not suitable for the plug supplied with this appliance, it should be cut off and an appropriate 3 pin plug fitted. For details, refer to the instructions described below.
Note: The plug severed from the mains lead must be destroyed, as a plug with bared flexible cord is hazardous if engaged in a live socket outlet.
SPECIAL INSTRUCTIONS FOR U.K. MODEL
IMPORTANT:
THE WIRES IN MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED. Making sure that neither core is connected to the earth terminal of the three pin plug.
WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE STANDBY/ON SWITCH IS PRESSED;
The IMPEDANCE SELECTOR switch may not be set to either end closely. If so, set the switch to either end closely.
IMPEDANCE SELECTOR
IMPEDANCE SELECTOR |
|
||
SET BEFORE POWER ON |
|
||
|
A OR B : 4ΩMIN. /SPEAKER |
|
|
|
A |
B : 8ΩMIN. /SPEAKER |
|
|
A OR B : 8ΩMIN. /SPEAKER |
|
|
|
A |
B : 12ΩMIN. /SPEAKER |
|
|
|
|
MAINS |
A |
|
|
|
B |
|
|
|
CAUTION |
|
|
l00W MAX. TOTAL |
SEE |
CORRECT SETTING. |
SWITCHED |
|
|
|
SPEAKERS |
AC OUTLETS |
(Europe model)
4
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER
Battery installation |
Remote control transmitter operation range |
English
2
1
Remote control sensor
|
|
Within approximately |
3 |
|
6 m (19.7 feet) |
|
|
|
30 |
|
° |
° |
30 |
|
|
|
Battery replacement
If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones.
Notes
●Use only AA, R6, UM-3 batteries for replacement.
●Be sure the polarities are correct. (See the illustration inside the battery compartment.)
●Remove the batteries if the remote control transmitter will not be used for an extended period of time.
●If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.
Notes
●There should be no large obstacles between the remote control transmitter and the main unit.
●If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp etc.), it might cause the remote control transmitter not to work correctly. In this case, reposition the main unit to avoid direct lighting.
5
Loading...