Wolf ICBCT15G, ICBCT30G, ICBCT36G, CBCT15S, ICBCT30S Installation Instructions Manual
...
GAS COOKTOPS
INSTALLATION INSTRUCTIONS
Model numbers
ICBCT36G/S
This cooktop is approved for use with
Leave instructions with the owner.
ICBCT15G/S
ICBCT30G/S
Natural and Propane gases.
As you follow these instructions, you will
notice WARNING and CAUTION symbols.
This blocked information is important for the
safe and efficient installation of Wolf equipment. There are two types of potential
hazards that may occur during installation.
Another footnote we would like to identify is
IMPORTANT NOTE: This highlights information that is especially relevant to a problemfree installation.
signals a situation where minor injury or
product damage may occur if you do not
follow instructions.
states a hazard that may cause serious
injury or death if precautions are not
followed.
WOLF®is a registered trademark of Wolf Appliance, Inc.
C O N T A C T
I N F O R M A T I O N
Imported a nd
distributed by:
Multyflex
Website:
www.multyflex.com.au
3
INSTALLATION REQUIREMENTS
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch.
Do not use any phone in your
building.
Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
If you cannot reach your gas
supplier, call the fire department.
WOLF GAS COOKTOPS
Installation to be carried out only
by an authorised person.
Do not modify this appliance.
Aventilationhoodisrecommended for use with the Wolf gas
multi-function cooktop.
Do not store or use gasoline or
other flammable vapors and
liquids in the vicinity of this or any
other appliance.
The use of a gas cooking appliance
results in the production of heat
and moisture in the room in which
it is installed. Ensure that the
kitchen is well ventilated; keep
natural ventilation holes open or
install a mechanical ventilation
device (mechanical extractor
hood).
Prolonged intensive use of the
appliance may for additional ventilation, for example opening of a
window, or more effective ventilation, for example increasing the
level of mechanical ventilation
where present.
This appliance shall be installed
in accordance with the regulations in force and only used in a
well ventilated space. Read the
instructions before installing or
using this appliance.
Installer: Please read the entire
Installation Instructions prior to
installation. Save these instructions
for the local inspector’s reference,
then leave them with the homeowner.
Homeowner: Please read and keep
these instructions for future reference and be sure to read the entire
Use & Care Information prior to use.
IMPORTANT NOTE:
be installed in accordance with the manufacturer’s installation instructions, local gas fitting
Australian Standard for gas installations. Refer
Statutory requirements: This appliance shall
regulations!and!authority,municipalbuildingcodes,
electrical wiring regulations, and AS5601 the
also to AS5601 for gas pipe sizing tables.
Not$suitable$for$use$in$marine$craft,$caravans$or$mobile$
homes,$unless$each$burner$is$fitted$with$a$flame$
safeguard.
4
B E F O RE Y O U S T A R T
Proper installation is your responsibility.
Have a qualified person install this cooktop.
You must also assure that electrical installation is adequate and in compliance with all
local codes and ordinances.
P
rior to installation, ensure that the local
distribution conditions (nature of the gas
and gas pressure) and the adjustment of
t
he appliance are compatible.
Proper gas supply connection must be
available; refer to Gas Supply Requirements
on page 10. Electrical ground is required;
see Electrical Requirements on page 11.
The adjustment conditions for this appliance are stated on the label (or rating
plate). The data plate can be found on the
underside of the cooktop.
W O L F G A S CO O K T O P S
Rating plate location
Location of rating
plate under cooktop
R AT I N G P L A T E
I N F O R M A T I O N
Model Number
Serial Number
IMPORTANT NOTE:
This manual covers installation instructions
for three cooktop models. i.e.:
2 burner cooktop - model ICBCT15G/S
4 burner cooktop - model ICBCT30G/S
5 burner cooktop - model ICBCT36G/S
5
I N S T A LL A T I O N I N S T R U C T I O N S
L O C A T I O N R E Q U I R E M E N T S
Illustrations on the following pages provide the
overall dimensions, countertop cut-out and
installation specifications for Wolf gas
cooktops. Maintain the following minimum
installation dimensions:
Minimum horizontal clearance from the
sides and back of the cooktop cut-out to
adjacent vertical combustible construction,
extending a minimum of 457 mm above the
countertop, is as follows: 178 mm from side
edges of cut-out for the 381 mm cooktop;
229 mm from side edges of cut-out for the
762 mm and 914 mm cooktops; 64 mm
from rear edge of cut-out.
Minimum vertical distance between the
countertop and combustible materials
above the cooktop must be 762 mm.
Maximum 330 mm depth of overhead side
cabinets directly above and within side
clearance.
IMPORTANT NOTE:
When installing a ventilation hood, refer to the specific requirements
of the hood for the minimum dimension to
countertop.
B E F O RE Y O U S TA R T
Check the location where the cooktop will
be installed. The location should be away
from strong draft areas, such as windows,
doors and strong heating vents or fans. Do
not obstruct flow of combustion and
ventilation air.
This appliance is not connected to a
combustion products evacuation device. It
s
hall be installed and connected in accordance with current installation regulations.
Particular attention shall be given to the
relevant requirements regarding ventilation.
S I T E P R E P A R AT I O N
C O U N T E R T O P C U T- O U T
D I M E N S I O N S
IMPORTANT NOTE:
Countertop opening
dimensions shown on the following pages
must be used. The dimensions shown provide
for required clearances.
These cooktops are designed to fit a standard
610 mm deep base cabinet with a 635 mm
deep countertop. Before making the countertop cut-out, verify that the cooktop will clear
the side walls of the base cabinet below. There
should be at least 140 mm clearance between
the countertop and any combustible surface
directly below the unit.
IMPORTANT NOTE:
Do not seal the cooktop
to the countertop. It must be removed if
service is necessary.
Failure to locate the cooktop without the
proper clearances will result in a fire
hazard.
This cooktop is intended for indoor use.
Loading...