Whirlpool PLT 1150 WA INSTRUCTION FOR USE
GB PLT 1150 WA PROGRAMME CHART
A. “Programme Sequence” Indication
B. Temperature Selection Knob
C. “Spin Speed Selection” Knob
D. “On/Off” Button
BADC
❉
: option / Yes: dosing required
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is restricted
to 800 rpm in this programme.
3)
For improved garment care, spin speed is zero in this
programme.
Programme
Cotton with prewash
Synthetic with prewash
Delicate with prewash
Cotton
Cotton short
Mixed Cotton/Synthetics
Synthetics
Delicate
Wool
Silk
Rinse + Gentle Spin
Rinse + Spin
Spin
Gentle spin
Drain
Care
Labels
—
—
—
—
—
Type of wash / Notes
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,
Nylon) or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton
and linen.
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton
and linen.
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon) or blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine
washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Same as the last two rinses and the final spin in the “Synthetic” programme. Programme for
treating wash with starch or softener.
Same as the last rinse and the final spin in the “Cotton” programme.
Programme for treating wash with starch or softener.
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
Max.
load
kg
5.0
2.0
1.5
5.0
3.0
3.0
2.0
1.5
1.0
1.0
2.0
5.0
5.0
2.0
Detergents and additives Special Options Tem pe ra-
Prewash Main
1)
Yes
1)
Yes
1)
Yes
—
—
—
—
—
—
—
——
——
Softener Bleach Half
Wash
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
❉❉❉ ❉
❉
❉
❉❉❉ ❉
❉
❉
❉
❉
❉
❉
❉
❉
Load
❉❉
—
——
❉❉
—
❉❉
—
❉❉
—
——
——
——
——
——
Rinse
Hold
❉
❉
❉
❉
❉
❉
ture
°C
Max. 95 1000
Max. 60
Max. 40
Max. 95 1000
Max. 60
Max. 60 1000
Max. 60
Max. 40
Max. 40
Max. 30
—
—
————— — —
————— — —
Max.
Spin
Speed
rpm
800
800
800
800
800
800
—
800
1000
1000
800
2)
2)
2)
2)
2)
2)
3)
2)
2)
———— —— — — —
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
5019 612 10086/A
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 95 5.0 63* 1.80 2:05
Cotton 60 5.0 55 0.95 2:05
Cotton 40 5.0 55 0.55 2:05
Mixed Cotton/Synthetics 60 2.0 56 0.80 1:30
Synthetics 40 2.0 56 0.40 1:30
Delicate 40 1.5 60 0.55 0:45
Wool 40 1.0 60 0.50 0:40
Silk 30 1.0 60 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the
values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE
1. Load the machine, close the drum flaps and
check that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the
“MAX”
level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
temperature selector knob
to the
desired temperature.
5. Turn the
spin speed selector knob
to the
desired spin speed. If the spin speed “ ” is
selected, the final spin is cancelled, but not the
intermediate spins. The programme ends with a
drain cycle.
SELECT THE DESIRED OPTION
Selecting or deselecting an option can be done
at any time during the programme. The
option will be applied as long as the
corresponding programme phase has not been
executed yet.
“Half Load” button
• Can be used for small loads and lightly soiled
laundry.
• Reduces the water consumption especially
during the rinses.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
• This option is particularly recommended for the
“Synthetics” and “Delicate” programmes.
• This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the
programme will terminate automatically with
the selected spin cycle.
• If you do not wish to spin the clothes, press the
“
” button, turn the programme
On/Off
selector knob to the “Drain” programme and
press the “
On/Off
” button again.
PROGRAMME START
Turn on the tap and press the “
On/Off
” button.
The pilot light lights up.
: If there is a power interruption or if the
Note
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop
position.
1. Press the “
” button to switch off the
On/Off
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the door to unlock (about 1 minute).
5. Open the door and the drum flaps and unload
the machine. Leave the lid open for some time
to allow the inside of the appliance to dry.
CHANGE THE PROGRAMME DURING
THE WASH CYCLE
1. Switch off the machine by pressing the
“
On/Off
” button.
2. Select the new programme.
3. Start programme by pressing the “
On/Off
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it
later:
1. Press the “
On/Off
” button.
2. After the desired pause, press again the
“On/Off”
button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the
“
On/Off
” button.
2. Set the programme selector to “Drain”.
3. Press the “
” button again to start the
On/Off
“Drain” programme.
”
5019 612 10086/A
Loading...