Whirlpool ET18SC Use And Care Manual

0
-
NO-FROST REFRIGERATOR-
FREEZER
Model ETl8SC
‘,S
Please read this Use and Care Guide before you do anything else.. .
This booklet tells you how to start your retrig­erator, clean it. move shelves and adjust con­trols. It even tells you what new sounds to expect from your refrigerator.
Treat your new refrigerator with care. Use it only to do what home refrigerators are de­signed to do.
Parts and features
Control
\
Juice
Can
1 Egg:::
- Butter Compartment
Copy your Model and Serial Numbers here...
When you need service, or call with a question,
have this Information ready
Model Number
1.
ComDlete Model and Serial Numbers [from the label’located as shown).
2. Purchase date from sales slop
Serial Number
Copy this Information In these spaces. Keep this book, your warranty and sales Slip together in a handy plcce There is no warranty reglstratlon to re-
Purchase Date
turn. Proof-of-purchase IS all that is required for In-
warranty sewice
Service Company and Telephone Number
2
I I I
Contents
SAFETY FIRST BEFORE YOU PLUG IT IN
Install Properly Level Refrigerator-Freezer : Remove Soles Labels Clean It Plug It In :
USING YOUR REFRIGERATOR
Setting the Controls Changing the Control Settings Power Saving Control Adjusting the Refrigerator Shelves Removing the Crisper, Trivet and
Crisper Cover
Changing the Light Bulb :
Page
3
3 4 4 4 4 4 5 5 5 5 6
Ice Cube Trays Sounds You May Hear Energy Saving Tips : : : : : :
CLEANING YOUR REFRIGERATOR
Cleaning Chart
FOOD STORAGE GUIDE : : : : :
Storing Fresh Food Storing Frozen Food : : : : : : :
VACATION AND MOVING CARE IF YOU NEED SERVICE OR ASSISTANCE
I. Before Calling for Assistance 2 If You Need Assistance 3 If You Need Sewice : : ”
4. If You Hove a Problem
Page
6 7
6 6
01986 Whirlpool Corporation
8 9
9 10 10 11 11 11 11 11
Before you plug it in
IMPORTANT
Before using your refrigerator, you are personally responsible for making sure that it...
l
is installed and leveled on a floor that will hold the weight, and in an area suitable for its size and use.
l
is connected only to the right kind of outlet, with the right electrical supply and grounding. [Refer to your “Electrical Requirements and Grounding Instructions:‘)
l
is used only for jobs expected of home re­frigerators.
l
IS not near an oven, radiator or other heat source.
l
IS properly maintained.
l
is out of the weather
l
is used in an area where the room temperature will not fall below 55” F (13” C].
l
is not used by those who may not understand how it should be used.
l
is not loaded with food before it has time to get properly cold.
I
1 I’
Install properly.. .
111;)i
0
1 I
1. Allow 3 inches (7.5 cm) between overhead cab­Inets and the refrigerator top
2. Allow at least an Inch (2.5cm) between the refrlg-
erator condenser and the wall
3. Allow % inch (1.25 cm] on each side of the rem frigerator for ease of lnstallatlon
4 If the refrigerator IS to be agolnst a wall, you might
want to leave enough space so the door can be opened wider
Level refrigerator-freezer...
Levelli
This refrigerator has 2 threaded levelling legs that are shipped in a separate package.
1. Screw these legs all the way into bolt holes in the bottom front corners of the refrigerator.
2. Slide the refrigerator into place.
3. Adjust front legs to level the refrigerator.
-To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction shown.
4. Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
inslde
labels before using the refrigerator.
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetmchloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrlgemtor at the front.
Clean it...
Clean your refrigerator before using It See clean-
Ing instructions on page 7
Plug it in...
3-prong
grounding plug
t
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused and properly grounded electrical supply is re­quired. It is recommended that a separate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep­tacle which cannot be turned off with a switch or pull chain.
See individual electrical require­ments and grounding instruction sheet in your liter­ature package.
4
Loading...
+ 8 hidden pages