Whirlpool ED5HHEXT, ED5CHQXV, ED5PVEXV, ED2DHEXW, ED2GVEXV User Manual

...

" (1.25 cm)

2" (5.08 cm)

Side by Side Refrigerator

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

ED2CHQXT

D5CHQXT

E ED2CHQXV ED2DHEXW ED5DHEXW

D2FHEXV

E ED2KVEXV ED5FHEXV ED5FVGXW

D2HBEXT

E ED5HBEXT

ED2HHEXT

D5HHEXT

E ED5HHGXT ED2JHEXT ED5JHEXT

D5KVEXV

E ED2LDEXW ED5LDEXW ED2LHEXT

D5LHEXT

E ED5PBEXT

ED5VBEXT

D2VHEXT

E ED5VHEXT ED2VHEXV ED5VHEXV

D5CHQXV

E ED5GVEXV ED5PVEXV ED2GVEXV

Electrical: A 115-Volt, 60-Hz., AC-only 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.

NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer control depending on the model) to the desired setting.

Water: A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required for the water dispenser and ice maker.

IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi (207 and 827 kPa).

If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa).

top of

cabinet

not incl.

andle

Model size "A" "B" "C" "D" "E"

22 cu.ft. 31-3/8" 32-3/4" 33-1/8" 65-7/8" 66-3/4"

25 cu.ft. 31-3/8" 35-1/2" 35-7/8" 68-7/8" 69-3/4"

Depth Cab. Width Door Width Cab. Height Overall Height

(79.7 cm) (83.2 cm) (84.1 cm) (167.3 cm) (169.6 cm)

(79.7 cm) (90.2 cm) (91.1 cm) (174.9 cm) (177.2 cm)

overall

Handle and door style w

ill vary with model.

imensions “D” and “E” include rollers extended 3/4" (1.9 cm).

LOCATION REQUIREMENTS

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

To ensure proper ventilation for your refrigerator, allow for 1/2”(1.25 cm) space on each side and at the top. When installing your refrigerator next to a fixed wall, leave 2”(5.08 cm) minimum on each side (depending on your model) to allow for the door to swing open. If your refrigerator has an ice maker, allow extra space at the back for the water line connections.

NOTE: Do not install the refrigerator near an oven, radiator, or other heat source, nor in a location where the temperature will fall below 55°F (13°C).

Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.

Ref. 2309541C

02-23-09