Whirlpool AWV 404 INSTRUCTION FOR USE
(1) Programme duration
figures (guideline) are
valid for maximum
temperature wash with
no special functions.
GB
AWV 404
PROGRAMME TABLE
1/2 Load
Rinse
Option
Cold Wash
Spin
Option
Prewash Delicate
Cotton Wool
Coloured Drain
Synthetics On/Off
Programme Type of fabrics / Degree of soiling / Notes Max.
Heavily soiled sheets, tablecloths, underclothes, shirts etc. in hard
Cotton with Prewash
Cotton
Coloured Cotton
Synthetics
Rinse + Spin
Spin
Delicates
Wool
Rinse + Spin
Spin
wearing and high temperature resistant cotto n.
The maximum load for heavily soiled washing is 3.5 kg.
Moderately soiled sheets, tablecloths, underclothes, towels etc. in
hard wearing and high temperature resistant cotton.
Moderately soiled sheets, tablecloths, underclothes, towels etc. in
hard wearing and temperature resistant cott on.
Lightly soiled shirts, blouses etc., made of polyester (Diolen,
Trevira), polyamide (Perlon, Nylon) or cotton blends.
This programme allows starch or softener to be ad ded.
It is followed by an intensive spin cycle.
Programme for intensive spin cycle.
Delicate fabrics and curtains (dresses, skirts, shirts, blouses, etc.). 1.5
Machine washable woollens with pure new wool label.
This programme allows starch or softener to be ad ded.
It is followed by a gentle spin cycle.
Programme for gentle spin cycle.
Load
kg
5.0 Yes Yes
5.0
5.0
2.0
5.0
5.0
1.0
1.5
1.5
Detergent and Additives Options Temperature
Pre-
wash
Washing Softener Bleach Half
—
—
—
——
—— ———— —
—
—
——
——
❉❉❉❉
Yes
Yes
Yes
Yes
Yes
❉❉❉❉
❉
❉
❉
❉
❉
❉
—
—
—
—
——
——
———
——— —
Load
Cold
Wash
❉❉
❉❉
❉
—
❉
❉
Maximum
Spin
Speed
°C
90 400 130
90 400 115
60 400 90
40 400 70
Cold 400 20
40 400 55
40 400 45
Cold 400 15
rpm
400 10
400 5
Programme
time
approx.
min (1)
Drain
Drain only, without spin cycle.
—— —
N.B.: The excess of detergent in the dispenser could cause technical problems.
—
——— — —
5019 100 01023
3
GB
ENERGY AND WATER CONSUMPTION DATA
Programme Temperature
(°C)
Cotton 90 5.0 72 1.80 115
Coloured Cotton 60 5.0 72 0.96 90
Synthetics 40 2.0 66 0.35 70
Delicates 40 1.5 70 0.65 55
Wool 40 1.0 70 0.55 45
Programmes with prewash last about 15 minutes more than programmes without prewash. Water and energy
consumption values were measured in standard conditions in compliance with the Standard IEC 60 456. Individual
consumption may vary in comparison with the values specified in the table, because of differences in supply water
pressure and temperature, the load and the type of wash.
Load
(kg)
Water
(l)
Energy
(kWh)
Programme
time
(min)
ADDING DETERGENT AND ADDITIVES
Pour the detergent and additives into the respective
compartments as follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and starch
• Bleach
• Stain removers
• Anti-scale agents (water hardness 4)
Important Note:
• Do not fill beyond the “
MAX”
level mark.
• For programme with prewash: do not use liquid
detergent.
• For programmes without prewash from cold to 40° C, it is recommended to use a liquid
detergent to avoid whitish residues on the coloured laundry.
CLOSE THE DOOR AND SELECT THE PROGRAMME
• Turn the
programme selector knob
clockwise to the desired programme.
SELECT ANY DESIRED OPTIONS
“Half Load” button
• Reduces the water consumption in the “Cotton” and “Synthetics” programmes
especially during the rinse.
• Especially suitable for lightly soiled or small loads (reduces the quantity of detergent).
• Not suitable for high temperature programmes.
“Cold Wash” button
• This option suppresses the heating of the water.
• You can use this option with all washing cycles.
PROGRAMME START
Open the water inlet tap and press the On/Off button “ ”. The pilot lamp lights up.
DOOR LOCK
During the running programme, the door cannot be opened.
The door locks automatically in all programmes.
If the programme is stopped or if an electrical power failure occurs, the door unlocks
automatically after about 1 minute.
PROGRAMME END
• The programme selector knob is at “STOP”.
1. Press the On/Off button “ ”. The pilot light goes out.
2. Cancel the options by pressing the appropriate buttons.
3. Turn the water supply tap off.
4. Wait for the door to unlock (about 1 minute).
5. Open the door and the drum flaps and unload the machine.
SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER
PROGRAMME START
1. Press the On/Off button “ ” to switch off the appliance.
The pilot light goes out.
2. Select the new programme and opti on s.
3. Press the On/Off button “ ” to switch on the appliance.
The pilot light lights.
TO STOP, RESET A PROGRAMME BEFORE THE END
1. Press the On/Off button “ ” to switch off the appliance.
The pilot light goes out.
2. Set the programme selector on “Drain”.
3. Press the On/Off button “ ” to start the “Drain” programme.
Only open the door when the programme selector is at “STOP” and
the door is unlocked (after approximately 1 minute).
5019 100 01023
Loading...