Whirlpool AWT 8128 INSTRUCTION FOR USE
GB
AWT 8128
ABC
Programme
Cotton 90°
with prewash
Synthetic 60°
with prewash
Delicate 40° with
prewash
Cotton
40°-60°-90°
Synthetic
60°-40°
Delicate 40° Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Wool 40°
Handwash 30°
Rinse + Gentle Spin
Rinse + Spin
Spin —
Gentle spin —
Care
Labels
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,
Nylon) or blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Same as the last two rinses and the final spin in the “Synthetic” programme.
—
wash with starch or softener.
Same as the last rinse and the final spin in the “Coloured Cotton” programme.
—
Programme for treating wash with starch or softener.
In this programme spinning is intensive. Same as the spin cycle in the “Coloured Cotton” programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
Type of wash / Notes
A. “Start” Button
B. “On/Off” Button
C. “Temperature” Indication lamps
Max.
load
kg
5.0
2.0
1.5
5.0
2.0
1.5
1.0
1.0
Programme for treating
2.0
5.0
5.0
2.0
“Cold”
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is restricted to
800 rpm in this programme.
3)
For improved garment care, spin speed is zero in this
programme.
Detergents and additives Special Options Max.
Prewash Main
1)
Yes
1)
Yes
1)
Yes
—
—
—
—
—
——
——
Softener Eco Rapid Intensive
Wash
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
❉❉❉ ❉❉
❉❉❉ ❉❉
❉
—— —
❉❉❉ ❉❉
❉❉❉ ❉❉
❉
❉
❉
❉
❉
—— —
—— —
—— —
—— —
—— —
Rinse
Rinse
Hold
❉
❉
❉
❉
❉
❉
Spin Speed
————— ——
————— ——
rpm
1200
800
800
1200
800
800
800
—
800
1200
1200
800
2)
2)
2)
2)
2)
3)
2)
2)
Drain —
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
—————————
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 00044
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 90 5.0 *63 1.8 2:05
Cotton 60 5.0 48 0.95 2:05
Cotton 40 5.0 55 0.55 2:05
Synthetic 60 2.0 56 0.8 1:35
Synthetic 40 2.0 50 0.4 1:30
Delicate 40 1.5 60 0.55 0:50
Wool 40 1.0 60 0.5 0:40
Handwash 30 1.0 60 0.3 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum flaps and check
that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Stain remover agents
• Anti-scale agents (if necessary)
3. Press the
the
lamp and, in case of availability, a temperature
indicator lamp light up.
4. Turn the programme selector knob to the desired
programme and temperature.
half a step for correct positioning. The
temperature indication (if available) switches
to the selected temperature.
“On/Off“
“On/Off“
“MAX“
level mark, as follows:
button . The pilot lamp of
button , a spin speed indicator
The knob will move
Selecting or deselecting an option can be done at
any time during the programme. The option will
be applied as long as the corresponding
programme phase has not been executed yet.
“Eco” button
• The duration of the wash is extended and the max
temperature reduced to save up to 40% of energy
compared to a normal wash but maintaining good
washing results.
“Rapid” button
• For fast, energy saving wash cycles.
• Ideally suited for small loads consisting of lightly
soiled laundry.
“Intensive Rinse” button
• One rinse cycle is added to ensure a more intensive
rinse.
• This option is particularly suitable for areas with
very soft water, washing baby linen and people
with detergents allergies.
“Spin Speed Selection” button
• The appliance selects the spin speed proposed
for the programme choosen.
• Press the button to set another spin speed.
• If the spin speed “0” is selected, the final spin is
cancelled, but not the intermediate spins. The
programme ends with a drain cycle.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
• This option is particularly recommended for the
“Synthetic” or “Delicate” programmes.
• This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Remark:
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the
• If you do not wish to spin the clothes, turn the
the programme selector knob stop on ““.
programme will terminate automatically with the
selected spin cycle.
programme selector knob to the “Drain”
programme
again.
and press the
“Start”
button
PROGRAMME START
Turn on the tap and press the
indicator lamp of the
Remark
: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it was
interrupted.
“Start”
“Start”
button lights up.
button
. The
END OF WASH CYCLE
• The programme selector knob is in the “Stop”
position.
1. Press the
machine.
2. Turn the tap off.
3. Wait for the door to unlock (about 1 minute).
4. Open the door and the drum flaps and unload
the machine.
“On/Off”
button to switch off the
CHANGE THE PROGRAMME DURING THE WASH
CYCLE
1. Turn the programme selector knob to the new
programme.
moves half a step and the pilot lamp of the
“Start” button flashes.
the additional options and the spin speed.
2. Start programme by pressing the
button
The programme selector knob
If necessary, select
.
“Start”
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the
2.
After the desired pause, press again on the
“On/Off”
“On/Off”
button
button .
.
CANCEL PROGRAMME
1. Set the programme selector to “Drain” .
2. Press the
“Drain” programme
“Start”
button to start the
.
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 00044
Loading...