Whirlpool AWT 6086 INSTRUCTION FOR USE
GB
AWT 6086
A. “Start” Button
B. “On/Off” Button
C. “Temperature” Indication lamps
D. “Spin Speed Selection” Button
ACDB
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is restricte d to
600 rpm in this programme.
3)
For improved garment care, spin speed is zero in this
programme.
Programme
Cotton 90°
with prewash
Synthetic 60°
with prewash
Delicate 40° with
prewash
Cotton
40°-60°-90°
Synthetic
60°-40°
Delicate 40°
Wool 40°
Silk 30°
Rinse + Gentle Spin
Rinse + Spin
Spin
Gentle spin
Drain
Cotone 90° con
prelavaggio
Sintetici 60° con
prelavaggio
Delicati 40° con
prelavaggio
Cotone
40°, 60°, 90°
Sintetici
60°-40°
Delicati
40°
Lana
40°
Seta
30°
Risciacquo +
Centrifuga
Risciacquo +
Centrifuga intensiva
Centrifuga intensiva
Centrifuga
Scarico acqua
Care
Labels
—
—
—
—
—
Type of wash / Notes
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,
Nylon) or blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Same as the last two rinses and the final spin in the “Synthetic” programme.
wash with starch or softener.
Same as the last rinse and the final spin in the “Coloured Cotton” programme.
Programme for treating wash with starch or softener.
In this programme spinning is intensive. Same as the spin cycle in the “Coloured Cotton” programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
Programme for treating
Max.
load
kg
5.0
2.0
1.5
5.0
2.0
1.5
1.0
1.0
2.0
5.0
5.0
2.0
Detergents and additives Special Options Max.
Prewash Main
1)
Yes
1)
Yes
1)
Yes
—
—
—
—
—
——
——
Softener Bleach Cold
Wash
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
❉ ❉❉❉ ❉ ❉
❉
❉
❉ ❉❉❉ ❉ ❉
❉
❉
❉
❉
❉
❉
Half
Wash
❉❉ ❉ ❉
—
❉
—
❉❉ ❉ ❉
—
❉
—
❉
—
❉
—
Inten-
Load
sive
Rinse
——
——
——
——
——— —
——— —
Rinse
Hold
❉
❉
❉
❉
❉
❉
————————
————————
Spin
Speed
rpm
800
600
600
800
600
600
600
—
600
800
800
600
2)
2)
2)
2)
2)
3)
2)
2)
————————— —
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 00061
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 90 5.0 *63 1.8 2:05
Cotton 60 5.0 55 0.95 2:05
Cotton 40 5.0 55 0.55 2:05
Synthetic 60 2.0 56 0.8 1:35
Synthetic 40 2.0 50 0.4 1:30
Delicate 40 1.5 60 0.55 0:50
Wool 40 1.0 60 0.5 0:40
Silk 30 1.0 60 0.3 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption valu es were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum flaps and check
that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Press the
the
and, in case of availability, a temperature
indicator lamp light up.
4. Turn the programme selector knob to the desired
programme and temperature.
half a step for correct positioning. The
temperature indication (if available) switches
to the selected temperature.
“On/Off“
“On/Off“
“MAX“
level mark, as follows:
button . The pilot lamp of
button, a spin speed indicator lamp
The knob will move
Selecting or deselecting an option can be done at
any time during the programme. The option will
be applied as long as the corresponding
programme phase has not been executed yet.
“Cold Wash” button
• This option suppress heating of the water.
• You can use this option with all washing cycles.
“Half Load” button
• Can be used for small loads an d lightly soiled laun dry.
• Reduces the water consumption especially during
the rinses.
“Intensive Rinse” button
• One rinse cycle is added to ensure a more intensive
rinse.
• This option is particularly suitable for areas with
very soft water, washing baby linen and people
with detergents allergies.
“Spin Speed Selection” button
• The appliance selects the spin speed proposed for
the programme choosen.
• Press the button to set another spin speed.
• If the spin speed “0” is selected, the final spin is
cancelled, but not the intermediate spins. The
programme ends with a drain cycle.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
• This option is particularly recommended for the
“Synthetic” or “Delicate” programmes.
• This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Remark:
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the
• If you do not wish to spin the clothes, turn the
the programme selector knob stop on .
programme will terminate automatically with the
selected spin cycle.
programme selector knob to the “Drain”
programme and press the
“Start”
button again.
PROGRAMME START
“Start”
button lights up.
“Start”
button. The
Turn on the tap and press the
indicator lamp of the
Note
: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it was
interrupted.
END OF WASH CYCLE
• The programme selector knob is in the “Stop”
position.
1. Press the
machine.
2. Turn the tap off.
3. Wait for the door to unlock (about 1 minute).
4. Open the door and the drum flaps and unload
the machine.
“On/Off”
button to switch off the
CHANGE THE PROGRAMME DURING THE WASH
CYCLE
1. Turn the programme selector knob to the new
programme.
moves half a step and the pilot lamp of the
“Start” button flashes.
additional options and the spin speed.
2. Start programme by pressing the
button.
The programme selector knob
If necessary, select the
“Start”
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the
2.
After the desired pause, press again on the
“On/Off”
“On/Off”
button.
button.
CANCEL PROGRAMME
1. Set the programme selector to “Drain”.
2. Press the
programme.
“Start”
button to start the “Drain”
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 00061
Loading...