Whirlpool AWT 3399 INSTRUCTION FOR USE
GB AWT 3399
Whirlpool is a registered trademark of Whirlpool USA
BA C
A. “Programme Selection” Knob
B. “Spin Speed Selection” Knob
C. “On/Off” Button
❉
: option / Yes: dosing required
1)
Do not use liquid detergents.
2
) For improved garment care, spin speed is zero in
this programme.
Programme
Cotton 90°
with prewash
Synthetic 60°
with prewash
Delicate 40°
with prewash
Cotton
90° - 60° - 40°
Daily Mixed 60’ Slightly to normally soiled textiles made of cotton and/or synthetics.
Synthetic 40°
Delicate 40° Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Wool 40°
Silk 30°
Rinse +
Gentle Spin
Rinse + Spin — Programme for treating cotton or linen laundry with starch or softener.
Spin — Programme to spin cotton or linen laundry intensively with maximum spin speed.
Gentle spin — Programme to spin delicate laundry gently with a restricted spin speed.
Drain — Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
Care
Labels
—
Type of wash / Notes
Heavily soiled bed linen, table linen and underwear , towels, shirts etc. made of cotton and linen.
Hea v i l y soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally to heavily soiled bed linen, table linen and underwear , towels, shirts etc. made of
cotton and linen.
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon) or blends with cotton.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine
washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Programme for treating delicate laundry with starch or softener.
N.B.This machine is controlled by sensors. Please avoid excessive detergent dosing.
Max.
load
kg
5.0
2.0
1.5
5.0
3.0
2.0
1.5
1.0
1.0
2.0
5.0
5.0
2.0
Detergents and additives Special Options Programme
Prewash Main
1)
Yes
1)
Yes
1)
Yes
—
—
—
—
—
—
——
——
Softener Bleach Cold
Wash
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
❉❉❉
❉
❉
❉❉❉❉❉❉
❉
❉
❉
❉
❉
❉
❉
Wash
—
—
—
—
—
—
—
Rapid Intensive
❉
❉
❉
Rinse
—
—
❉❉
❉❉
——
—
❉❉
❉❉❉❉
❉
❉
❉
——
——
——
————
————
Rinse
Hold
❉
❉
❉
❉
❉
❉
————————
————————
—————————
selector knob
Max.
Spin
Speed
rpm
Prew. Cotton 800
Prew. Synthetic 800
Prew. Delicate 800
Cotton
90°, 60°, 40°
800
800
Synthetic 40° 800
Delicate 40° 800
Wool 40°
Silk 30°
Rinse & Gentle
Spin
800
—
800
2)
Rinse & Spin 800
Spin 800
Gentle Spin 800
Drain
—
5019 312 10286
Whirlpool is a registered trademark of Whirlpool USA
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 90 5.0 63* 1.80 2:05
Cotton 60 5.0 55 0.95 2:05
Cotton 40 5.0 55 0.55 2:05
Daily Mixed 60’ 40 3.0 49 0.48 1:00
Synthetic 40 2.0 56 0.40 1:05
Delicate 40 1.5 60 0.55 0:45
Wool 40 1.0 60 0.50 0:40
Silk 30 1.0 60 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the
values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump
drains the water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum doors and
check that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the “MAX“ level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the programme selector knob to the
desired programme and temperature.
4. Turn the spin speed selector knob to the
desired spin speed. If the spin speed “0” is
selected, the final spin is cancelled, but not the
intermediate spins. The programme ends with a
drain cycle.
Selecting or deselecting an option can be
done at any time during the programme. The
option will be applied as long as the
corresponding programme phase has not
been executed yet.
“Cold Wash” button
• This option suppresses the heating of the water.
• You can use this option with all washing cycles.
“Rapid” button
• For fast, energy saving wash cycles.
• Ideally suited for small loads consisting of lightly
soiled laundry.
“Intensive Rinse” button
• The amount of water is increased to ensure a
more intensive rinse.
• This option is particularly suitable for areas with
very soft water or washing linen laundry for
people with skin allergies.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
• This option is particularly recommended for the
“Synthetic”, “Delicate” and “Daily Mixed 60’”
programmes.
• This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Note: the programme selector knob stops
on .
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the
programme will terminate automatically with the
selected spin cycle.
• If you do not wish to spin the clothes, press the
“On/Off” button, turn the programme selector
knob to the “Drain” programme and press the
“On/Off” button again.
PROGRAMME START
Turn on the tap and press the “On/Off” button. The
indicator light of the “On/Off” button lights up.
Note: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop
position.
1. Press the “On/Off” button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
Open the lid and the drum doors and unload the
5.
machine.
CHANGE THE PROGRAMME DURING THE
WASH CYCLE
1. Switch off the machine by pressing the
“On/Off” button.
2. Select the new programme.
Start programme by pressing the “On/Off”
3.
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the “On/Off” button.
2. After the desired pause, press again the
“On/Off” button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the
“On/Off” button.
2. Set the programme selector to “Drain”.
3. Press the “On/Off” button again to start the
“Drain” programme.
5019 312 10286
Loading...