Whirlpool AWT 2082/1 INSTRUCTION FOR USE

GB AWT 2082/1
Programme
Cotton with prewash Prelavaggio Cotone
Synthetic with prewash Prelavaggio Sintetici
Delicate with prewash Prelavaggio Delicati
A CB D
Care
Labels
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen,Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Type of wash / Notes
A. Programme Selection Knob B. Temperature Selection Knob C. Spin Speed Selector Knob D. “On/Off” Button
Max. Load
kg
5,0 Yes
2,0 Yes
1,5 Yes
i : option / Yes: dosing required
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is restricted
to 700 rpm in this programme.
3)
For improved garment care, spin speed is null in this
programme.
Pre-
Main
wash
Softener Bleach Eco Half
wash
Eco Mezzo
1)
Yes
1)
Yes
1)
Yes
i i i i i
i
i
i i i
Load
Carico
Rinse Hold
Anti
Piega
i
Tempera-
Max.
ture
Speed
°C
Max. 90 800
Max. 60 700
Max. 40 700
Spin
rpm
2)
2)
Cotton Cotone
Coloured Cotton Colorati
Daily Mixed
Synthetics Sintetici
Synthetic short Sintetici breve
Delicate Delicati
Wool Lana
Silk Seta
Rinse + Gentle
Spin
Risciacquo & Centrif.
breve
Rinse + Spin Risciacquo & Centrifuga
Spin Centrifuga
Gentle Spin Centrifuga breve
Drain Scarico acqua
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Slightly to normally soiled textiles made of cotton and/or synthetics.
Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Normally soiled overalls ans sportswear made of cotton, polyester, polyamide and blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Same as the last two rinses and the final spin in the “Synthetic” programme. Programme for treating
wash with starch or softener.
Same as the last rinse and final spin in the “Cotton” programme. Programme for treating wash with starch or softener.
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
5,0 Yes
3,0 Yes
3,0 Yes
2,0 Yes
1,5 Yes
1,5 Yes
1,0 Yes
1,0 Yes
2,0
5,0
i i i i i
i
i
i
i
i
i
i
i
i
i i i
i i i
i i i
i i
i i
i i
i
i
i
Max. 90 800
Max. 60 800
Max. 60 800
Max. 60 700
Max. 60 700
Max. 40 700
Max. 40 700
Max. 30
700
800
5,0 800
2,0 700
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 10375
2)
2)
2)
2)
3)
2)
2)
CONSUMPTION DATA
Programme
Temperature
Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 90 5,0 63* 1,80 2:05
Cotton 60 5,0 55 0,95 2:05
Cotton 40 5,0 55 0,55 2:05
Daily Mixed 40 3,0 49 0,48 1:00
Synthetic 60 2,0 56 0,80 1:30
Synthetic 40 2,0 56 0,40 1:30
Delicate 40 1,5 60 0,55 0:45
Wool 40 1,0 60 0,50 0:40
Silk 30 1,0 60 0,30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard EN/IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum doors and check that they are properly locked.
2. Add detergents and additives into the dispenser to no more then the “MAX” level mark, as follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and conditioners
Chlorine bleach
Stain remover agents
Anti-scale agents (if necessary)
3. Turn the programme selector knob to the desired programme.
4. Turn the temperature selector knob to the desired temperature.
5. Turn the spin speed selector knob to the desired spin speed. If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle.
Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.
“Eco Wash” button (Eco)
The duration of the wash is extended and the
temperature reduced to save up to 40% of energy compared to a normal wash but maintaining good washing results.
“Half Load” button (Mezzo Carico)
Can be used for small loads and lightly soiled laundry.
Reduces the water consumption especially during
the rinse.
“Rinse Hold” button (Anti Piega)
The laundry remains in the last rinse water without
progressing to the final spin cycle to avoid creasing and prevent colours from fading.
This option is particularly recommended for the “Synthetic”, “Delicate” and “Daily Mixed” programmes.
This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.
Note: The programme selector knob stops on .
Appliance in “Rinse Hold”:
Press the “Rinse Hold” button again: the
programme will terminate automatically with the selected spin cycle.
If you do not wish to spin the clothes, press the “On/Off” button, turn the programme selector knob to the “Drain” programme and press the “On/Off” button again.
PROGRAMME START
Turn on the tap and press the “On/Off” button. The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.
END OF WASH CYCLE
The programme selector knob is in the Stop
position.
1. Press the “On/Off” button to switch off the machine.
2. Cancel the option.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
5. Open the lid and the drum doors and unload the machine.
CHANGE THE PROGRAMME DURING THE WASH CYCLE
1. Switch off machine by pressing the “On/Off” button.
2. Select the new programme.
3. Start programme by pressing the “On/Off”
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the programme for a certain time and continue it later:
1. Press the “On/Off” button.
2. After the desired pause, press again the “ON/Off” button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the “On/Off” button.
2. Set the programme selector to “Drain”.
3. Press the “On/Off” button again to start the “Drain” programme.
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 10375
Loading...