Whirlpool AWT 2062 INSTRUCTION FOR USE

GB AWT 2062

Programme

Cotton with prewash

Synthetic with

prewash

Delicate with prewash

Cotton

Coloured Cotton

Synthetic

Synthetic short

Delicate

Wool

Silk

Rinse + Gentle

Spin

Rinse + Spin

Spin

Gentle Spin

Drain

Risciacquo & Centrif.

Risciacquo & Centrifuga

Centrifuga breve

Prelav. Cotone

Prelav. Sintetici

Prelav. Delicati

Cotone

Colorati

Sintetici

Sintetici breve

Delicati

Lana

Seta

breve

Centrifuga

Scarico acqua

A CB

Care

Labels

Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen,Trevira), polyamide (Perlon,
Nylon) or blends with cotton.

Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.

Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton
and linen.

Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Normally to heavily soiled blouses, shirts, overalls etc. made of polyester ( Diolen, Trevira),
polyamide (Perlon, Nylon) or blends with cotton.

Normally soiled overalls ans sportswear made of cotton, polyester, polyamide and blends with
cotton.

Curtains and delicate clothing, dresses, skirts, shirts and blouses.

Only woollens with a felt-free finish, labelled with the woolmark and identified as machine
washable.

If you select “Rinse Hold” do not leave items to soak for too long.

Textiles made of silk, linen, wool and viscose marked as “handwashable”.

If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Same as the last two rinses and the final spin in the “Synthetic” programme. Programme for

–

treating wash with starch or softener.
Same as the last rinse and final spin in the “Cotton” programme. Programme for treating wash

–

with starch or softener.

In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.

–

In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.

–

Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.

–

Type of wash / Notes

A. Programme Selection Knob
B. Temperature Selection Knob
C. “On/Off” Button

Max.
Load

i : option / Yes: dosing required

1)

Do not use liquid detergents.

2)

For improved garment care, spin speed is restricted to

550 rpm in this programme.

3)

For improved garment care, spin speed is null in this

programme.

Detergents and Additives Special Options

Pre-

Main

wash

wash

kg

5,0 Yes 1)Yes

2,0 Yes 1)Yes

1,5 Yes 1)Yes

5,0 – Yes

3,0 – Yes

2,0 – Yes

1,5 – Yes

1,5 – Yes

1,0 – Yes

1,0 – Yes

2,0 – –

5,0 – –

Softener Bleach Half

Load

Mezzo
Carico

i i i i

i

i

–

– –

i i

i i i i

i

i

i

i

i

i

i

i

–

–

–

– –

– –

– –

– –

– –

i i

i i

i i

Rinse

Hold

Anti

Piega

i

i

i

i

i

i

Tempera-

ture

Max. Spin

Speed

°C

Max. 90 600

Max. 60 550

Max. 40 550

Max. 90 600

Max. 60 600

Max. 60 550

Max. 60 550

Max. 40 550

Max. 40 550

Max. 30 –

– 550

– 600

rpm

5,0 – – – – – – – 600

2,0 – – – – – – – 550

– – – – – – – – –

2)

2)

2)

2)

2)

2)

3)

2)

2)

N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.

Whirlpool is a registered trademark of Whirlpool USA.

5019 312 10268

CONSUMPTION DATA

Programme

Temperature

Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)
Cotton 90 5,0 63* 1,80 2:05
Cotton 60 5,0 55 0,95 2:05
Cotton 40 5,0 55 0,55 2:05

Synthetic 60 2,0 56 0,80 1:30
Synthetic 40 2,0 56 0,40 1:30

Delicate 40 1,5 60 0,55 0:45

Wool 40 1,0 60 0,50 0:40

Silk 30 1,0 60 0,30 0:50

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.

The data on the “Energy Label” refer to the programme “Cotton 60°C”.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the
pump drains the water out.

PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION

1. Load the machine, close the drum doors and
check that they are properly locked.

2. Add detergents and additives into the
dispenser to no more then the “MAX” level

mark, as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (if necessary)

3. Turn the programme selector knob to the
desired programme.

4. Turn the temperature selector knob to the
desired temperature.

5. Turn the spin speed selector knob to the
desired spin speed.

Selecting or deselecting an option can be done
at any time during the programme. The option
will be applied as long as the corresponding
programme phase has not been executed yet.

“Half Load” button Mezzo carico

• Can be used for small loads and lightly soiled

laundry.

• Reduces the water consumption especially
during the rinses.

“Rinse Hold” button Anti Piega

• The laundry remains in the last rinse water

without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.

• This option is particularly recommended for the
“Synthetic”, “Delicate” and “Daily Mixed”
programmes.

• This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.

Note: The programme selector knob stops on .

Appliance in “Rinse Hold”:

• Press the “Rinse Hold” button again: the

programme will terminate automatically with
the selected spin cycle.

• If you do not wish to spin the clothes, press the
“On/Off” button, turn the programme selector
knob to the “Drain” programme and press the
“On/Off” button again.

PROGRAMME START

Turn on the tap and press the “On/Off” button.
The indicator light of the “On/Off” button lights up.
Note: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.

END OF WASH CYCLE

• The programme selector knob is in the Stop

position.

1. Press the “On/Off” button to switch off
the machine.

2. Cancel the option.

3. Turn the tap off.

4. Wait for the lid to unlock (about 1 minute).

5. Open the lid and the drun doors and unload
the machine.

CHANGE THE PROGRAMME DURING THE
WASH CYCLE

1. Switch off machine by pressing the “On/Off”
button.

2. Select the new programme.

3. Start programme by pressing the “On/Off”

button again.

PAUSE/INTERRUPT A PROGRAMME

If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:

1. Press the “On/Off” button.

2. After the desired pause, press again the
“ON/Off” button.

CANCEL PROGRAMME

1. Switch off the machine by pressing the
“On/Off” button.

2. Set the programme selector to “Drain”.

3. Press the “On/Off” button again to start the
“Drain” programme.

Whirlpool is a registered trademark of Whirlpool USA.

5019 312 10268