Whirlpool AWG 779 INSTRUCTION FOR USE
Whirlpool is a registered trademark of Whirlpool USA
30120153GB.fm Page 1 Wednesday, April 2, 2008 11:09 AM
AWG 779 PROGRAMME CHART
A
A. Programme selector
B. “Start” button
C. “No spin” button
O. “Prewash” button
B CO
Programme
White Cotton
Antibacterial
Cotton
Synthetics
Delicates
W ool
Lingerie
Handwash
Quick wash
Tempe-
rature
90 °C
60 °C
30 - 40 °C
30 - 60 °C
40 °C
40 °C
Care
Labels
——
30 °C
35 °C
Type of wash/Notes
- For temperature selection, respect the manufacturer’s recommendations on the care label
Normally to heavily soiled bed linen, table linen and underwear , towels, shirts etc. made
of cotton and linen.
At a temperature of 80°C or more, this programme eliminates bacteria, ensuring
sanitization of your laundry . The bacteria removal efficiency has been tested following a
similar methodology to the NF EN 13697 standard of Nov. 2001.
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon) or blends with cotton.
Curtains and delicate clothing, skirts, shirts and blouses.
Only woollens labelled with the Woolmark and identified as machine washable.
This programme (40°C) is tested and approved by The Woolmark Company for
handwashable wool.
Curtains and delicate clothing in wool or silk only washable in cold water.
Garments made of linen, silk, wool and viscose marked as “handwashable”.
Outer clothing worn for short periods and made of cotton, polyester, polyamide and
cotton blends.
Detergents and additives Special functions
Pre-
wash
L
L
—
—
—
—
—
Main
wash
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Softener Pre-
wash
No spin
LL L
LL L
L
L
L
L
L
—
——
—
—
—
L
L
L
L
Cold wash
Rinse
Drain
Spin
: optional / Yes : dosing required
L
1)
For improved garment care, spin speed is restricted in these programmes.
Black process 45.0° 150.0 LPI
——
——
——
Slightly soiled garments in cotton and/or synthetics washable only in cold water.
Same as the last rinse and the final spin in the “Cotton” programme.
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme.
The “wool” programme of this washing machine has been approved by The Woolmark Company for the washing of
garments labelled as “machine washable”. Follow the instructions given on the label sewn on the garment and the
—
——
——— —
instructions supplied by the washing-machine manufacturer. (Cert. no. M0402-M0403-M0404-M0405).
Yes
L
L
—
—
5019 301 20153
L
L
L
Whirlpool is a registered trademark of Whirlpool USA
30120153GB.fm Page 2 Wednesday, April 2, 2008 11:09 AM
ADD DETERGENTS, CLOSE THE DOOR
AND SELECT THE PROGRAMME
Add detergent as indicated on the front page and as
described in the chapter “Detergent and Additives”
in the Instructions for Use.
1. Turn the
programme selector
to the desired
programme.
SELECT ANY DESIRED OPTION
Press the buttons of any required options - the
respective indicator lights up.
When the combination of programme and
additional option(s) is not possible,
the indicators switch off automatically. Unsuitable
combinations of options are deselected
automatically.
“Prewash” button
• Only for heavily soiled loads (e.g. sand, granular
dirt). Increases the cycle time by approx.
15 minutes.
• Do not use liquid detergent for the main wash
when activating the prewash option.
“No spin” button
• Excludes spinning from programme, press
button. Suitable for delicate laundry.
with the “Cotton” and “Synthetics”
Note:
programmes a short spin cycle is provided in any
case, even if the exclusion has been selected, in
order to optimize rinsing results.
PROGRAMME START
Open the tap and press the
indicator next to the
“Start”
“Start”
. The
button lights up.
“DOOR OPEN” INDICATOR
At the end of a programme the “Start” button
indicator flashes signalling that the door can be
opened. As long as a wash programme is running,
the door remains locked and must not be forced
open. In case you have an urgent need to open it
during a running programme, refer to “Cancel
(Reset) a running programme before the end”.
PROGRAMME END
• At the end of the wash cycle the “Start” button
indicator flashes signalling that the door is
unlocked.
1. Turn the programme selector to the “Off/O”
position.
2. Close the water tap.
3. Open the door and unload the machine.
4. Leave the door ajar to allow the drum to dry.
CHANGING PROGRAMME AND/OR
OPTIONS AFTER PROGRAMME START
1. Turn the programme selector to “Off/O”.
2. Select the new programme, any options and
another spin speed if you want.
3. Press the
“Start”
button again. The new
programme resumes the wash programme
from where the previous one was interrupted.
Do not add detergent for this programme.
CANCEL (RESET) A RUNNING
PROGRAMME BEFORE THE END
• Reset by turning the programme selector to
“Off/0” and select the “Drain Spin” programme
to remove the water remaining in the bowl
before the door can be opened.
Black process 45.0° 150.0 LPI
5019 301 20153
Loading...