Whirlpool AWE 6515/P INSTRUCTION FOR USE
GB AWE 6515/P PROGRAMME CHART
B
A
Programme
Cotton 95°
with prewash
Synthetic 60°
with prewash
Delicate 40°
with prewash
Cotton
95° - 60° - 40°
Daily Mixed 40°
Synthetic 40°
Delicate 40°
Wool 40°
Handwash 30°
Rinse +
Gentle Spin
Rinse + Spin
Spin
Gentle spin
Drain
Pranie Wstępne
Bawełniane 95°
Pranie Wstępne
Syntetyczne 60°
Pranie Wstępne
Delikatne 40°
Bawełniane
95° - 60° - 40°
Codzienne 60 min.
Syntetyczne 40°
Delikatne 40°
Wełniane 40°
Pranie ręczne 30°
Płukanie i delikatne
wirowanie
Płukanie i wirowanie
Wirowanie
Delikat. wirowanie
Wypompowanie
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
Care
Labels
—
—
—
—
—
Type of w a s h / Notes
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton
and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide
(Perlon, Nylon) or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made
of cotton and linen.
Slightly to normally soiled textiles made of cotton and/or synthetics.
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon).
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Only woollens with a felt-free finish, labelled with the woolmark and identified as
machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Programme for treating delicate laundry with starch or softener.
Programme for treating cotton or linen laundry with starch or softener.
Programme to spin cotton or linen laundry intensively with maximum spin speed.
Programme to spin delicate laundry gently with a restricted spin speed.
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
C
D
A. “Start” Button
- lights up when activated -
B. Programme sequence indicator
C. “Spin Speed Selection” Button
D. “On/Off” button
- does not light up when activated
(the dot on the button is not a lamp) -
Max.
load
kg
5.0
2.0
1.5
5.0
3.0
2.0
1.5
1.0
1.0
2.0
5.0
5.0
2.0
Detergents and additives Special Options Max.
Prewash Main
Yes
Yes
Yes
Wash
1)
1)
1)
—
—
—
—
—
—
——
——
———————
———————
—— — — — — — — —
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is restricted
to 700 rpm in this programme.
3)
For improved garment care, spin speed is zero in
this programme.
Softener Bleach Half load Intensive
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
❉❉❉ ❉ ❉
❉
❉
—
—— —
❉❉❉ ❉ ❉
❉
❉
❉
❉
❉
❉
❉
—
—
—— —
—— —
—— —
—
—
Rinse
Hold
Stop
płukanie
Połowa
ładunku
Rinse
Super
płukanie
❉❉❉
❉
❉❉❉
❉❉❉
❉
❉
❉
❉❉❉
❉❉❉
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10424
Spin
Speed
rpm
1000
700
700
1000
1000
700
700
700
—
700
1000
1000
700
2)
2)
2)
2)
2)
3)
2)
2)
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours :minutes)
Cotton 95 5.0 63* 1.80 2:05
Cotton 60 5.0 52 0.95 2:05
Cotton 40 5.0 52 0.60 2:05
Daily Mixed 40 3.0 49 0.48 1:00
Synthetic 60 2.0 56 0.80 1:30
Synthetic 40 2.0 56 0.40 1:20
Delicate 40 1.5 60 0.55 0:45
Wool 40 1.0 60 0.50 0:40
Handwash 30 1.0 60 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the
values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE
1. Load the machine, close the drum doors and
check that they are properly locked.
2. Add detergents and additives into the dispenser to
no more than the
“MAX”
level mark, as follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Press the
The lamp of the
“On/Off”
button.
“Start”
button flashes.
4. Turn the programme selector knob to the
desired programme. The lamp of the
SELECT THE DESIRED OPTION
Selecting or deselecting an option can be done
at any time during the programme. The option
will be applied as long as the corresponding
programme phase has not been executed yet.
“Half Load” button
• Can be used for small loads and lightly soiled
laundry.
• Reduces the water consumption especially
during the rinses.
“Intensive Rinse” button
• The amount of water is increased to ensure a
more intensive rinse.
• This option is particularly suitable for areas with
very soft water, washing baby linen and people
with skin allergies.
programme’s standard spin speed lights up.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from
fading.
• This option is particularly recommended for
the “Synthetic”, “Delicate” and “Daily Mixed”
programmes.
• This function is particularly useful if you want
to postpone spinning to a later time, or if you
want to drain only.
• As soon as the appliance stops in the rinse
hold, the lamp of the
“Start”
button flashes.
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button or the flashing
“Start”
button: the programme will terminate
automatically with the selected spin cycle.
• If you do not wish to spin the clothes, turn the
programme selector knob to the “Drain”
programme and press the
“Start”
button
again.
Spin Speed selection button
• Every programme has an automatically preset
spin speed.
• Press the button to set another spin speed.
• If spin speed “0” is selected, the final spin is
cancelled, and the programme ends with a drain
cycle.
PROGRAMME START
Verify that the appliance is switched on.
Turn on the tap and press the
The indicator lamp of the
“Start”
“Start”
button.
button stops
flashing and lights up.
: If there is a power interruption or if the
Note
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
END OF WASH CYCLE
• The “End” lamp of the programme sequence
indicator lights up.
1. Press the
“On/Off”
button to switch off the
machine.
2. Turn the tap off.
3. Wait for the lid to unlock (about 1 minute).
4. Open the lid and the drum doors and unload
the machine.
to allow the inside of the appliance to dry.
Leave the lid open for some time
CHANGE THE PROGRAMME DURING
THE WASH CYCLE
1. Switch the appliance off by pressing
“On/Off”
2. Turn the programme selector knob to the
new programme.
3. Switch the appliance on again by pressing
“On/Off”
. The “Start” button flashes. If
necessary, select additional options and
different spin speed.
4. Start programme by pressing the
“Start”
button.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the
“On/Off”
button.
2. After the desired pause, press again on the
“On/Off”
button.
CANCEL PROGRAMME
1. Switch off the appliance by pressing
“On/Off”
2. Turn the programme selector to “Drain”.
3. Switch the appliance on again by pressing
“On/Off”
. The lamp of the
“Start”
button
flashes.
4. Press the
“Start”
button to start the “Drain”
programme.
.
.
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10424
Loading...