Whirlpool AWA 5105 INSTRUCTION FOR USE

AWA 5105

B CA D

A. Programme Selection Knob B. Temperature Selection Knob C. “Spin Speed Selection” Knob D. “On/Off” Button

❉

: option / Yes: dosing required

Do not use liquid detergents.

For improved garment care, spin speed is restricted to 800 rpm in this programme.

For improved garment care, spin speed is zero in this programme.

Programme

Cotton with prewash

Prélav. Coton

Synthetic with prewash

Prélav. Synthét.

Delicate with prewash

Prélav. Délicat

Cotton

Coton

Coloured Cotton

Couleur

Daily Mixed

Synthetic

Synthétique

Synthetic short

Synthétique Fragile

Delicate

Délicat

Wool

Laine

Silk

Soie

Rinse + Gentle Spin

Rinçage & Essorage Doux

Rinse + Spin

Rinçage & Essorage

Spin

Essorage

Gentle spin

Essorage doux

Drain

Vidange

Care

Labels

—

Type of wash / Notes

Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.

Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.

Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.

Normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton and linen.

Slightly to normally soiled textiles made of cotton and/or synthetics.

Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.

Normally soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton.

Curtains and delicate clothing, dresses, skirts, shirts and blouses.

Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.

If you select “Rinse Hold” do not leave items to soak for too long.

Textiles made of silk, linen, wool and viscose marked as “handwashable”.

If you select “Rinse Hold” do not leave items to soak for too long. No spinning.

Programme for treating delicate laundry with starch or softener.

Programme for treating cotton or linen laundry with starch or softener.

Programme to spin cotton or linen laundry intensively with maximum spin speed.

Programme to spin delicate laundry gently with a restricted spin speed.

Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.

N.B.This machine is controlled by sensors. Please avoid excessive detergent dosing.

Max. load

5.0

2.0

1.5

5.0

3.0

2.0

1.5

1.0

2.0

5.0

2.0

Detergents and additives Special Options Tempera-

Prewash Main

Yes

—

——

Softener Bleach Intensive

Wash

Yes

❉❉❉ ❉ ❉ ❉ ❉❉❉ ❉ ❉

❉ ❉

❉ ❉ ❉ ❉ ❉ ❉

Rinse

Rinçage

Plus

—

❉❉

——

—

❉❉ ❉❉ ❉❉

❉❉

——

Rinse

Hold

Arrêt Cuve

Pleine

❉

❉ ❉ ❉ ❉ ❉

ture

°C

Max. 90 1000

Max. 60

Max. 40

Max. 90 1000

Max. 60 1000

Max. 60

Max. 40

Max. 30

—

——— — — — —

Max. Spin

Speed

rpm

800

—

800

1000

800

——— — — — — — —

Whirlpool is a registered trademark of Whirlpool USA.

5019 312 00122

CONSUMPTION DATA

Temperature Selector

Programme

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes) Cotton 90 5.0 63* 1.80 2:05 Cotton 60 5.0 55 0.95 2:05 Cotton 40 5.0 55 0.55 2:05

Daily Mixed 40 3.0 49 0.48 1:00

Synthetic 60 2.0 56 0.80 1:35 Synthetic 40 2.0 50 0.40 1:30

Delicate 40 1.5 60 0.55 0:50

Wool 40 1.0 60 0.50 0:40

Silk 30 1.0 60 0.30 0:50

Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.

The data on the “Energy Label” refer to the programme “Cotton 60°C”.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the

water out.

PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION

1. Load the machine, close the drum doors and check that they are properly locked.

2. Add detergents and additives into the dispenser to no more then the

“MAX”

level mark, as

follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (if necessary)

3. Turn the

programme selector knob

to the

desired programme.

4. Turn the

temperature selector knob

to the

desired temperature.

5. Turn the

spin speed selector knob

to the desired spin speed. If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle.

Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.

“Intensive Rinse” button

• One rinse cycle is added to ensure a more intensive rinse.

• This option is particularly suitable for areas with very soft water, washing baby linen and people with detergents allergies.

“Rinse Hold” button

• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading.

• This option is particularly recommended for the “Synthetic”, “Delicate” and “Daily Mixed”

programmes.

• This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.

Note:

the programme selector knob stops on .

Appliance in “Rinse Hold”:

• Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle.

• If you do not wish to spin the clothes, press the

On/Off

“

” button, turn the programme selector

knob to the “Drain” programme and press the

On/Off

“

” button again.

PROGRAMME START

Turn on the tap and press the “ The indicator light of the “

On/Off

” button.

” button lights

up.

Note

: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.

END OF WASH CYCLE

• The programme selector knob is in the Stop

position “”.

1. Press the “

On/Off

” button to switch off the

machine.

2. Cancel the options.

3. Turn the tap off.

4. Wait for the lid to unlock (about 1 minute).

Open the lid and the drum doors and unload

the machine.

CHANGE THE PROGRAMME DURING THE WASH CYCLE

1. Switch off the machine by pressing the

On/Off

“

” button.

2. Select the new programme. Start programme by pressing the “

On/Off

”

button again.

PAUSE/INTERRUPT A PROGRAMME

If, for any reason, you wish to interrupt the programme for a certain time and continue it later:

1. Press the “

On/Off

” button.

2. After the desired pause, press again the

“On/Off”

button.

CANCEL PROGRAMME

1. Switch off the machine by pressing the

On/Off

“

” button.

2. Set the programme selector to “Drain”.

3. Press the “

On/Off

” button again to start the

“Drain” programme.

Whirlpool is a registered trademark of Whirlpool USA.

5019 312 00122