INTRODUCT10N
Before leaving the factory each oven is carefulty checked.
It must however, be instalted and used correctly.
Despite all the steps taken to make the oven safe, the safety is dependent on the correct installation and the fact the user
understands how to use and maintain the oven.
The information in this section should be used as areminder thai the oven is safe and thai anyone who uses it must first
read the instructions tor use in order to be able to use the oven correctly and obtain the best results.
SAFETY
To avoid injury to yourself and damage to the appliance always work to the following rules when servicing an oven.
.Always disconnect the plug tram the mains before starting work.
If there is no plug switch-off the electricity supply at the control box.
.When you have finished servicing an oven before you reconnect it to the mains, make sure thai:
-alt the internat connections are correct
-the wires are insulated and not touching the door or the cabinet or anything sharp
-alt the earth connections are electricalty and mechanicalty sound
-do not modity or anyway intertere with the safety devices built-in to the oven
-make sure that each replacement part you use conforms to the manufacturer's specifications
.00 not start arepair if you have any doubt as to your ability to complete it.
".
CAUTION -MICROWAVE RADIATION
PERSONNEL SHOULD NOT BE EXPOSED TO THE MICROWAVE ENERGY WHICH MAY RADIATE FROM THE
MAGNETRON, WAVEGUIDE OR ANTENNA IFTHEY ARE IMPROPERLY USED OR CONNECTED. ALL INPUT AND OUTPUT MICROWAVE CONNECTIONS, WAVEGUIDES, FLANGES AND GASKETS MUST BE SECURE.
NEVER OPERATE THE DEVICE WITHOUT A MICROWAVE ENERGY ABSORBING LOAD ATTACHED.
NEVER LOOK INTO AN OPEN WAVEGUIDE OR ANTENNA WHILE THE DEVICE IS ENERGIZED.
NEVER OPERATE AN OVEN WITH CABINET OFF WITHOUT MEASURING THE MICROWAVE LEAKAGE AROUND
MAGNETRON AND VISIBLE MICROWAVE CONNECnONS (WELDING JOINTS).
00 not operate the oven if the foltowing conditions exist:
-The door does not close firmly against the door support because of the door being warped or the hinges damaged.
-The door trims or seals are damaged.
-If there is any visible damage to the oven.
-If the door does not close properly.
Avoid operating the oven if known components in the interlock system, oven door or microwave generating assembly are
known defective. They must be replaced. .
WARNING -HIGH VOLTAGE
IT IS POSSIBLETO GaME IN CONTACTWITH LETHAL HIGH VOLTAGE WHEN WORKING WITH HVTRANSFORMER, HV
CAPACITOR, AND MAGNETRON.
THEREFORE NEVER TRY TO MEASURE THE HIGH VOLTAGE. ALWAYS TAKE UTMOST CARE WHEN PERFORMING
ELECTRIC MEASUREMENTS INSIDE THE OVEN.