Whirlpool AMW 882 User And Maintenance Manual

AMW 882
User and maintenance manual
EN
Table of contents
IMPORTANT SAFETY INSTRUCTIONS 4
SCRAPPING OF HOUSEHOLD APPLIANCES 7
DECLARATION OF CONFORMITY CE 7
INSTALLATION
BEFORE FIRST USE
MOUNTING HE APPLIANCE
PRIOR TO CONNECTING
AFTER CONNECTING
PUSH-PUSH KNOBS
ACCESSORIES
GENERAL
CHOOSING COOKING CONTAINER
SPONGE
DRIP TRAY
ST E A M T RA Y
WATER CONTAINER
APPLIANCE FEATURES
7
8 8
8 8
9
9
10 10
10 10 10 10 10
11
CONTROL PANEL
START PROTECTION / KEY LOCK
11
11
3
CHANGING SETTINGS 12
CLOCK SETTING 12 BRIGHTNESS 13 SOUND SETTING 13 ECO 13 CA L I B R A T E 14
e
SPECIALS 15
KITCHEN TIMER 15
DESCALING 16 DRAINING 17
MANUAL STEAM 18
QUICK STEAM
POULTRY 21 FISH / SHELLFISH 21 VEGETABLES 22
20
MAINTENANCE & CLEANING 23
GENERAL 23 DISHWASHER SAFE 23 REMOVING THE SHELF SUPPORTS 24 DISHWASHER UNSAFE 24 REPLACING THE OVEN LIGHT BULB 24
TROUBLE SHOOTING GUIDE
TECHNICAL SPECIFICATION
4
25
25
IMPORTANT SAFETY INSTRUCTIONS
EN
YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT
This manual and the appliance itself provide important safety warnings, to be read and observed at all times.
This is the danger symbol, pertaining to safety, which alerts users to potential risks to themselves and others. All safety warnings are preceded by the danger symbol and the following terms:
DANGER
Indicates a hazardous situation which, if not avoided, will cause serious injury.
WARNING
Indicates a hazardous situation which, if not avoided, could cause serious injury.
A details of the potential risk present and indicate how to reduce risk of injury, damage and electric shock resulting from improper use of the appliance. Carefully observe the following instructions:
esolc snoitcurtsni eseht peeK-
at hand for future reference.
ot sevolg evitcetorp esU­perform all unpacking and installation operations.
eb tsum ecnailppa ehT­handled and installed by two or more persons.
a ehT­disconnected from the power supply before carrying out any installation work.
must be carried out by a
compliance with the manufacturer’s instructions and local safety regulations. Do not repair or replace any part of the appliance unless
eb tsum ecnailpp
ecnanetniam dna noitallatsnI-
manual.
4
EN
tnemecalper elbac rewoP-
must be carried out by a
Contact
an authorised service centre.
eht taht eriuqer snoitalugeR-
appliance is earthed. O-
its housing, the power cable must be long enough to connect the appliance to the main power supply.
current safety regulations, an omnipolar switch with minimum contact gap of 3 mm must be used.
,sdael noisnetxe esu ton oD-
multiple socket adapters.
to a socket which can be operated by remote control or timer.
ylp
pus rewop eht llup ton oD-
cable.
stnenopmoc lacirtcele ehT­must not be accessible to the user after installation.
ecnailppa eht hcuot ton oD­with any wet part of the body and do not operate it when barefoot.
ilppa sihT­solely for use as a domestic appliance for cooking food. No other type of use is permitted (e.g.: heating rooms). The Manufacturer declines any liability for injury to persons or animals or damage to property if these advices and precautions are not respected.
htiw ylpmoc ot noitallatsni roF-
accessible parts become hot during use. Care should be taken to avoid touching heating elements.
young children (3-8 years)
ecnailppa eht tcennoc ton oD-
shall be kept away unless continuously supervised.
and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, can use this appliance only if they are supervised or have been given instructions on safe appliance use and understand the hazards involved. Children must not play with the appliance. Cleaning and user maintenance must not be performed by children without supervision.
dengised si ecna
sti dna ecnailppa ehT-
dna )sraey 3-0( gnuoy yreV-
evoba dna sraey 8 fo nerdlihC-
5
touch the heating elements or interior surfaces of the appliance – risk of burns. Do not allow the appliance to come into contact with cloths
until all the components have cooled down completely.
t tA- he end of cooking, exercise caution when opening the appliance door, letting the hot air or steam exit gradually before accessing the oven. When the appliance door is shut, hot air is vented from the aperture above the control panel. Do not obstruct the vent apertures.
- Use oven gloves to remove pans and accessories, taking care not to touch the heating elements.
D­materials in or near the
if the appliance is inadvertently switched on.
or containers in the appliance. The pressure that builds up inside might cause the jar to explode, damaging the appliance.
synthetic materials.
ton od ,esu retfa dna gniruD-
Always remain vigilant when cooking foods rich in fat and oil.
- Never leave the appliance unattended during food drying.
used when cooking foods (e.g. rum, cognac, wine), remember that alcohol evaporates at high temperatures. As a result, there is a risk that vapours released by the alcohol may
contact with the electrical heating element.
re easily. Always remain vigilant when cooking foods rich in fat, oil or alcohol (e.g. rum, cognac, wine).
- Never use steam cleaning equipment.
probe recommended for this oven.
sraj delaes kooc ro taeh ton oD-
cleaners or sharp metal scrapers to clean the oven door glass as they can scratch the surface, which may result in the glass shattering.
ht taht erusnE-
fo edam sreniatnoc esu ton oD-
the lamp to avoid the possibility of electric shock.
hctac staf dna slio detaehrevO-
EN
era segareveb cilohocla fI-
hctac staf dna slio detaehrevO-
epmet eht ylno esU- rature
evisarba hsrah esu ton oD-
si ecnailppa e
6
EN
- This appliance is manufactured with recyclable or reusable materials. Scrap the appliance in
so that the appliances cannot be connected to the mains.
- For further information on the treatment, recovery and recycling of household electrical appliances, contact a competent local authority, the collection service for household waste or the store where the appliance is purchased.
SCRAPPING OF HOUSEHOLD APPLIANCES
DECLARATION OF CONFORMITY
THIS OVEN , which is intended to come into
European Regulation ( has been designed, manufactured and sold in
conformity with the safety requirements of the “Low Voltage” directive 2006/95/CE (which replaces 73/23/CEE and subsequent amendments), the protection requirements of “EMC” 2004/108/CE.
D
ISPOSAL OF PACKAGING MAT ERIALS
The packaging material is 100% recyclable and is marked with the recycle symbol (
The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal.
NERGY SAVING TIPS
E
- Only pre-heat the microwave oven if
- Use dark lacquered or enameled baking moulds as they absorb heat far better.
-S before the set cooking time. Food requiring prolonged cooking will continue to cook
) n. 1935/2004 and
SAFEGUARDING THE ENVIRONMENT
).
HIS APPLIANCE MEE TS the eco design requirements
T
of European regulations n. 65/2014 and n. 66/2014 in conformity to the European standard EN 60350-1.
SCRAPPING THE PROD UCT
- This appliance is marked in conformity with European Directive 2012/19/EU, Waste Electrical and Electronic Equipment (WEEE).
- By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
- The symbol accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment.
on the product or on the
7
INSTALLATION
EN
AFTER UNPACKING THE APPLIANCE, make sure that it has
not been damaged during transport and that the appliance door closes properly.
N THE EVENT OF PROBLEMS, contact the dealer or the
I
nearest After-sales Service.
T
O PREVENT ANY DAMAGE, only remove the appliance
from its polystyrene foam base at the time of installation.
MOUNTING THE APPLIANCE
F
OLLOW THE SUPPLIE D SEPARA TE MOUN T ING INS TRUC TIONS
when installing the appliance.
PRIOR TO CONNECTING
C
HECK THAT THE VOLTAGE on the rating plate
corresponds to the voltage in the home.
E
NSURE THE APPLIANCE oven cavity is empty before
mounting.
E
NSURE THAT THE APPLIANCE IS NO T DAMAGE D . Check
door support and that the internal door seal is not damaged. Empty the appliance oven and clean the interior with a soft, damp cloth.
D
O NO T OPERA TE this appliance if it has a damaged
mains cord, if it is not working properly, or if it has been damaged or dropped. Do not immerse the mains cord in water. Keep the cord away
C
HILDREN SHOULD NOT perform installation
operations. Keep children away during installation of the appliance. Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, during and after the installation of the appliance.
I
F THE POWER CABLE is too short or damaged it must
be replaced. The power cable must only be
compliance with the manufacturer instruction and current safety regulations. Contact an authorized service center.
T
HE POWER SUPPLY COR D must be long enough for
housing, to the main power supply.
OR INS TALLATION to comply with current safety
F
regulations, an omnipolar disconnect switch with minimum contact gap of 3 mm must be utilized.
hazards may result.
AFTER CONNECTING
HE APPLIANCE can be operated only if the
T
THE EART HING OF THIS APPLIANCE IS COMPULSORY . The
manufacturer will accept no responsibility for injury to persons, animals or damage to objects arising from the non-observance of this requirement.
HE MANUFAC T URERS are not liable for any
T
problems caused by the user’s failure to observe these instructions.
8
Loading...
+ 18 hidden pages