Whirlpool AKM 474NB INSTRUCTION FOR USE

3gb66033.fm Page 1 Thursday, May 22, 2003 9:28 AM

AKM 474 PRODUCT DESCRIPTION SHEET

1. Radiant cooking zone Ø 180, 1700W

2. Haloring cooking zone Ø 145, 1200W

3. Large burner

4. Small burner

5. Front left cooking zone control knob

6. Rear left cooking zone control knob

7. Large burner control knob

8. Small burner control knob

Symbols

Operation of burners with safety device and electric ignition

To light one of the burners:

• Press the relative knob an d turn it anti-clockwise to the large flame and star setting .

• At the same time, hold th e kn ob d own un til th e burner ignites.

• After the burner has ignited, keep th e knob pressed for about 10 seconds.

• Release the knob.

If the burner does n ot ignite, repeat the oper ati on s described above.

Note:

— Should particular local conditions of the

delivered gas make ignition of the burner difficult, it is advisable to repeat the operation with the knob turned to the small flame setting .

Shaded circle

Large flame and star

Small flame

— The burner safety device shuts off the gas

supply to the burner if the flame goes out accidentally (because of a sudden draught, an interruption in the gas delivery, boiling over of liquids, etc.).

— The separator panel, positioned beneath the

cooktop at a minimum distance of 20 mm, must be sealed.

Tap closed Maximum opening/delivery

and electric igniti on Minimum opening or

reduced delivery

A wooden shelf must be installed below the cooktop with a minimum thickness of 20 mm, at least 15 mm from the bottom of the surface itself.

5019 319 66033

3gb66033.fm Page 2 Thursday, May 22, 2003 9:28 AM

DIMENSIONS OF COOKING HOB AND WORKTOP (mm)

NOTES: If the distance “A” between the wall cabinets is between 600 mm and 680 mm, the

height “B” must be a minimum of 520 mm. If the distance “A” between the wall cabinets is greater than the width of the cooktop, the height “B” must be a minimum of 400 mm. Before installing a hood above the cooktop please refer to the hood instructions, which specify the correct distance.

INJECTORS TABLE CATEGORY II2E+3+

Type of gas used Type of

NATURAL GAS (Methane) G20

NATURAL GAS (Groningue) G25

LIQUID PETROLEUM GAS (Cylinder) G30

LIQUID PETROLEUM GAS (Cylinder) G31

Type of gas used Appliance model Total rated heat

G20 20 mbar 2 Gas+2VC 4.0 381 l/h 8.0 G25 25 mbar 2 Gas+2VC 3.71 411 l/h 7.42 G30 28-30 mbar 2 Gas+2VC 4.0 291 g/h 8.0 G31 37 mbar 2 Gas+2VC 4.0 285 g/h 8.0

burner

large small

Injector marking

130833.00

130832.78

85503.00

Rated heat capacity kW

1.00

0.93

1.00

capacity kW

Rated consumption

286 l/h

95 l/h

308 l/h 103 l/h

218 g/h

73 g/h

214 g/h

71 g/h

Total rated consumption

Reduced heat capacity kW

0.80

0.50

0.80

0.50

0.80

0.50

0.80

0.50

Gas pressure mbar

min. rat. max.

17 20 25

20 25 30

20 28-30 35

25 37 45

Air required for burning m

ELECTRIC SUPPLY:

230 V - 50 Hz

VETROCERAMIC HOT PLATE POWER: Rear left zone:

1200W

Front left zone: 1700W