Whirlpool ADP 9699/3 WH, ADP 9695/3 WH INSTRUCTION FOR USE

GB

ADP 9699

PROGRAMME CHART

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt.

Start button indicator lamp

Switches on when the dishwasher is operating.
Flashes when a fault occurs.

Switches off at the end of the programme.

Programme progress indicator

Pre-rinse

Only lights up for programmes with prewash (the
symbol “+” in the table below indicates that
detergent must be added).

Rinsing / Washing

Drying
Programme end

Programme
Symbol and

temperature

Pre-rinse

Rapid 40° C
Eco 50° C
Universal 65° C

Normal 65°C
Intensive 70° C

*) Values for normal conditions. Values may vary in relation to usage, e.g. different loads, water temperatures, water hardness and power supply voltage.

Crockery to be washed later.
Lightly soiled crockery with no dried-on food.

2)

Normally or heavily soiled crockery with dried-on food.
Normally soiled crockery.

1)

Normally or heavily soiled crockery.
Heavily soiled pans and saucepans.

Load

Crockery and cutlery

Detergent

Pre-rinse

(small

compartment)

--5.00.029---

- + 13.0 0.85 30 - - -

+ + 16.0 1.40 86 - - -

- + 14.0 1.50 73 - - ­+ + 20.0 1.63 98 - - ­+ + 22.5 1.75 93 - - -

Washing

(large

compartment)

Consumption *

Normal load

Water
(Liter)

Energy

(kWh)

Time

(Min.)

1) Programme recommended when using detergents of type A (non enzyme-based detergents).

2) Programme recommended when using d eter gen tsof type B (enzyme-based detergents).
Reference programme for Test Institute and energy label.

(We reserve the right to make technical modifications)

5019 100 91162

Quick Reference Guide

GB

Daily check list

1. Arrange crockery so that items do
not touch each other.

2. Load cups at an inclination to
facilitate water circulation.

3. In general, place the cutlery in the
basket with the handles positioned
downwards, but ensure that sharp
knives and forks that might cause
injury are placed in the basket with
the handles positioned upwards.

4. Make sure the water je t can reach
all loaded items and that the spray
arms rotate freely.

5. Turn on the water supply tap before
starting the dishwasher.

Important:

• Switch off the dishwasher once
the “Start” indicator lamp has
switched off. If you switch off the
dishwasher during a wash cycle,
when switched on again th e
dishwasher resumes the cycle
from where it was interrupted.

• If a fault occurs or you wish to
change the current programme,
press the “START” button for
about 5 seconds until the Start
indicator lamp switches off !
Refer to the “Troubleshooting
Guide” in these user instructions
to remedy any problems.

• If regeneration salt is to be
added, IMMEDIATELY start
a washing programme, to
eliminate any residual salt.

• Sometimes even when the
regeneration salt container is full,
the corresponding indicator
lamp may illuminate during the
first wash cycle.

Crockery holders:

• Down: cups and long-stemmed
glasses.

• Up: plates.

Upper rack

Height adjustment:

(The dishwasher is delivered with the
upper rack in the top position).

The rack height can also be changed
when loaded.

• To lower: pull out the two side
handles and gently lower the rack.

• To raise: pull up the two side
handles until the rack clicks into
place.

• The rack must be level on both
sides.

Lower rack

Cutlery basket:

The cutlery basket can be removed to
increase available space.

Plate holders:

• May be removed to increase
available space.

• To remove: pull the handle up.

• To reposition: simply insert in the

required position (normal or
crosswise).