Whirlpool ADG 9840/1 INSTRUCTION FOR USE

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Open the door,

switch on the appliance

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Select a programme

Press the ON button.

Compartment
With each wash cycle.
Compartment
For programmes with pre-wash only.
If using combined action dishwasher

tabs, follow the user instructions!

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener
system only.

Mechanical indicator D. Electric
indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The display shows the last programme selected.
Press P or until the selected programme lights up.

A:

B:

ABC

Select options

Press the Start button

Turn on the water tap

close the dishwasher door

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is
then memorised (even in the
event of power failure).

At the end of the programme an acoustic signal will sound and
appear on the display. Once the
all the indicator lights will switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme in progress”

1. Press the “Reset” button.

2. Automatic drai ni ng approx. 30 sec.

3. Select a new programme.

4. Select the desired options again (except
“Set detergent” - if provided and “Water
hardness setting”).

5. Start the dishwasher again by pressing the
Start button.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

will

button has switched off: press

Start

“End”

OFF

,

Dishwasher loading instructions and racks provided

Upper rack:
Multi-purpose support (A):

Depending on the position, for long­handles utensils, cups and glasses. May be
used in three different positions.

Crockery holders (B):

Depending on the position, for example
plates, cups and long-stemmed glasses.

Revolving glass support (C):

Depending on the position, for example
small or long-stemmed glasses.

Long-handled utensils (e.g. carving forks,
knives) must be arranged with the sharp
end facing in towards the appliance.

Half Load:

Load the upper rack (see description of
Options).
Place the cutlery basket (D) in the upper
rack.

Rack height adjustment
(also when loaded):

•

Lower adjustment:

rack handles outwards (E) and lower
the rack.

•

Upper adjustment:

handles (E) upwards until the rack
clicks into place (Factory setting).

The rack must be level on both sides.
Removing the top rack to provide

clearance for large items of crockery in
the bottom rack:

Open the rack guide retainers (F) on the
right and left and remove the top rack.
When the upper rack is in place the
retainers must always be closed.

1)

2)

pull out the

pull the

two

two

depending on the model

Retainer

closed

F

Retainer

F

open

Lower rack:

Depending on the model with fixed, tilting
(G) or tilting split plate holders (H).

Half Load:

Load the lower rack (see description of
Options).
Greater washing power, particularly for
plates and saucepans.

I

Power Clean load

Increased wash power in the dedicated area
(I) and high flexibility for lower rack loading.

H

Cutlery basket (J) or (L):

Some models are provided with a grid (K)
that can be fitted onto the cutlery basket to
keep items separated. Cutlery basket (D), if
provided, for appliances with half load only.

Sharp knives and forks that might
cause injury must be placed in the
cutlery basket with the sharp end
facing downwards.

Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a dishwasher, for example
wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery .
Spare parts which are sold separately:

1)

Multi-purpose support (A) - N. AMH 369 series.

2)

Revolving glass support (C) - N. WGH 1000 series.